Question about 1991 Ford F250

1 Answer

Wont idle 1991 Ford F250 Pickup 351 wisner Fuel injected when cold hasn't been started in a day will start and idle real good real smooth when put into gear and go to move will die then when try to start back will not start unless acelator held to floor when does start have to keep pumping acelator to run but wont idle unless pumping

Posted by on

  • seacarter193 Apr 19, 2009

    I have the same problem.I put it in gear it dies,you have to let it warm up.It also slow to come to idle when your driving.Idles at about 1200 rpm for 4 sec. then drops to norm.



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Sounds like dirty fuel check your fuel filters see if ther blocked

Posted on Jan 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a F250, 5.0 1985 FUEL INJECTED Engine that will not start cold, why?

Bad coolant temp sensor. This part asks as choke on FI engines. Some older FI engines also have a cold start injector. Check to see if yours does.

Feb 23, 2015 | 1985 Ford F 250

1 Answer

My ford f250 pickup truck isnt getting any power to the fuel pump

check the fuel pressure is this injected if so put a psi gadge on rail or just put the rubber hose into a quart jar an see if ya get a good flow
...if not could be the filter or pump....check wires to pump

Nov 25, 2013 | 1989 Ford F 250

1 Answer

1991 pickup 22re motor starts for 2seconds and then stalls or turns over and no start. Once in a great while will start and stay running but doesnt run smooth. Acts like its running on two or three...

hav you check your plugs after it happens? a black plug will tell it has too much fuel, a wite plug no fuel at all, leads tours a faulty cold start injector, you can also try to keep it alive with carb or throtle cleaner if idles you not getting enougth fuel. keep in mind compresion test, and valve adjust, this engines require it has a regular service.
good luck

Apr 15, 2012 | 1991 Toyota Pickup

1 Answer

1979 ford f250 wont start unless i put gas in CARB

first of all you have no carb its fuel injected, at least you know you have spark, now do you have fuel pressure??, is the fuel pump working?/ if you have fuel and pressure then you have to check signal at the injectors, so if you have fuel pressure and a good injector pulse the next step is to check the injectors, this may require removal, good luck

Nov 16, 2009 | 1995 Ford F250

2 Answers

87 chevy 350 fuel injected pickup wont run smoothly. Will start fine when cold and run for a few minutes then will be rough idle before finally quitting. I have replaced the distrubuter, coil, plugs, plug...

sounds like your egr valve is gummed up or bad. this is located behind the throttle body and has a single vaccum tube connected to it. if the diafram is still good you can remove it and clean it with WD 40 until the plunger works smooth

Nov 08, 2009 | 1987 Chevrolet S-10 Pickup

1 Answer

1991 F-250. feul injected 460 w/c6 tranny. acts like it is missing when engine runs at 3000rpms. accelerates just fine and runs wonderfully below 2900 rpms. just when i try to plane out around 70 mph the...

Hello. katienjoe. the fuel line from the filter to the fuel rail has a restrictor in the line its at the fitting at the rail. the opening messures 3/16 of a inch. so loaded it doesn't pull above 50 mph. you can change the line I did on mine the hot rod shops can supply what you need.

Sep 14, 2009 | 1991 Ford F250

2 Answers

86 Ford F350 Cold Start Problem

Does it have a carburetor or is it fuel injected? In 1986 it could be either way. It sounds like a carburetor with a choke problem.

Mar 24, 2009 | 1986 Ford F 350

Not finding what you are looking for?
1991 Ford F250 Logo

Related Topics:

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5627 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides