An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: 2005 reset switch oil change .
To manually reset it , turn the key to the on position with the engine off , depress the accelerator pedal 3 times slowly to the floor within 5 seconds , if change engine oil flashes for 5 seconds oil life monitor is reset ...
if the vehicle is equipped with a driver information center , reset the oil monitor by pressing driver information center SELECT button for 5 seconds while Engine Oil Life is displayed .
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Press your reset button on the on board diagnostics which is located on the dash, keep pressing the rest button until you see "oil life" once you come to the oil life, hold the reset button until it reads "Oil Life 100 percent" release the reset button, shut the vehicle off then re start it, that will turn off the message in the message center telling you to change your oil.
SWITCH THE IGNITION ON.ENGINE OFF,SLOWLY DEPRESS AND RELEASE THE ACCELERATOR PEDAL 3 TIMES WITHIN 5 SECONDS.WHEN CHANGE ENGINE OIL LIGHT FLASHES INDICATING RESETTING DONE.SWITCH IGNITION OFF.START ENGINE OIL LIFE WILL CHANGE TO 100 %.
It's a reminder that it's time to do your maintanence(oil change, tire rotation, replace air fliter, etc..your service book will tell you what service your need to do base on the mileage). A lot of the time people just get a oil change and reset the light. The light can be reset at anytime.
With the headlight OFF push and hold the trip/reset button or stick (located in front of the gauge below the MPH speedo) , turn the ignition switch ON (II), and continue to hold the button for more than 40 seconds. If you did it right the light should go out.
look in your manual in dash,has it in there, my 07 silverodo has to turn on switch push gas pedal 3 times then turn off switch, turn on switch again to clear it out ,look in your manual for oil change reset.hope to help you,robert b.
If you are talking about the change oil message on your cluster. You need to press step until oil change mileage appears on screen and then just press reset.
If you are inquiring about the oil pressure swith on the engine there is no reset procedure. If you just replaced the oil pressure switch and still have no oil pressure, you are going to have to use a manual oil pressure gauge to make sure that you have engine oil pressure. If you have oil pressure with the manual guage there is a problem with the wiring or engine computer.
TURN IGNITION KEY TO ON POSITION THEN BACK TO OFF 3 TIMES 3RD TIME
LEAVE IT IN ON POSITON THEN DEPRESS GAS PETAL TO FLOOR 3 TIMES. TURN
KEY OFF SHOULD BE RESET
On my 2005 impala you turn the ignition on and turn the radio
off. Push down the tune nob until settings is displayed on the radio.
Push the seek button until you see oil life. Push the next button on
the radio until you see the word reset then push the tune nob again.
this will reset the oil timer on the car and change oil light should