Question about 1994 Chevrolet S-10 Blazer

1 Answer

NO POWER TO FOUR WHEEL DRIVE

I have a 1994 chevy blazer and the problem is the push button switch for four wheel drive is not lit up and working at all could some one tell me what the problem could be

Posted by on

  • Anonymous Mar 14, 2014

    no power to four wheel drive switch

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 56 Answers

It could be a fuse or a relay not conducting the power to the switch have a local tech test it with a voltometer. it should be free to diagnos.

Posted on Jan 07, 2009

1 Suggested Answer

  • 33 Answers

SOURCE: 1994 chevy s10 blazer 4x4 push button type

small sylinoid on the top of the transfer case needs replaced. easy to do. it has three vacumelines going to it just trun out and replace like a bolt.

Posted on Dec 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i put my 94 s10 blazer into for wheel drive?


There should be a button on the dash. Push either 4hi or 4 low to activate the four wheel drive.

Nov 14, 2014 | 1994 Chevrolet S-10 Blazer

2 Answers

2000 blazer 4 wheel drive problem


It's most likely the "four wheel drive actuator" This is located on the front differential housing. It's cylindrical shaped and has a large hex (about
1-1/4") and two wires coming out of it. Usually they short out and blow the fuse but, I've also seen where they just quit working and sometimes they just get slow to work. The "actuator" has a heating element in it and it warms up, some sort gas, causing it to expand thus engaging the front wheels. In cold weather it may take a minute or so for it to engage, so put in four wheel drive and wait for a bit and see what happens.

Jan 05, 2010 | 2000 Chevrolet Blazer

1 Answer

1994 Chevrolet S-10 Blazer, not going in to Four Wheel Drive.


could be a bad 4wd actuator or solenoid- those arent terribly expensive to fix- but a bad transfer case is expensive. either way id recommend putting it in the shop if you need 4wd


Oct 31, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

Four wheel drive won't engage


Try to rock it by putting it into D an R it works for my truck.

Feb 18, 2009 | 1994 Ford F150 Styleside Supercab

1 Answer

1993 4X4 BLASER 4WHEEL DRIVE


Your blazer is equipped with a shift on the fly four wheel drive. That means that at speeds less than fifteen miles per hour you can shift into or out of four wheel drive by simply pushing the four wheel high button. If you wish to shift into four wheel low. Stop, put the transmission into park or neutral, and push the four wheel low button. Same procedure for shifting back out. Never shift into or out of four wheel low while moving. And be careful in four wheel low. At full throttle your still barely moving, you don't want to blow your engine up!

Dec 31, 2008 | 1994 Chevrolet S-10 Blazer

1 Answer

1994 chevy s10 blazer 4x4 push button type


small sylinoid on the top of the transfer case needs replaced. easy to do. it has three vacumelines going to it just trun out and replace like a bolt.

Dec 10, 2008 | 1994 Chevrolet S-10 Blazer

1 Answer

Four Wheel Drive switch lights at start up, but does not engage


The four wheel drive indicator light switch/ shift cable housing should be mounted on the front drive axle. The cable actuator vacuum diaphragm, or the switch assembly could be bad. You might want to check those. I hope this helps.

Dec 07, 2008 | 1994 Chevrolet S-10 Blazer

4 Answers

2001 Chevy Blazer 4 wheel drive


The four wheel drive systems in these vehicles are simple. The push button controls the four wheel drive computer. The computer tells the encoder motor (on transfer case) to shift. When the transfer case shifts there is a vaccum switch on the transfer that is activated which sends vaccum to the accuator under the battery. The accuator pulls a cable to lock the front axle in. This covers all s series trucks and suv's with push button four wheel drive but not with auto or all wheel. Now to answer some questions. If your push button is lit up but will not go in to four high you should try to reset the four wheel drive computer. To reset pull the courtesy light and atc fuses for sixty seconds install fuses then cycle key on and off 5 times. If your transfer case shifts but your front end does not lock in check for vaccum at the switch on the transfer case in and out. If no vaccum out replace switch motormite number 49315 at parts store. If you have vaccum out check accuator.

Jun 02, 2008 | 2001 Chevrolet Blazer

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...