Question about 2002 Ford Mustang

2 Answers

Turn Signal Not Working, But Parking & Back Brake Light Does

My turn signal stopped flashing. I figured it was just the bulb. Replaced the side lamp bulb and found that only one filament lights up, the parking light. The filament for the turn signal will not light up. The back turn signal does work so I know it's not the turn signal switch. Maybe a ground wire? Any suggestions?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 95 mustang my break lights and turn signals and hazzards dont work.

Posted on Jun 22, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 56 Answers

I would say try to replace the relay,(it should be in the fuse box) for the signals. if it's not that it could be the brain it's located in the colum of the steering unit.

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The right turn signal front is not working, All else works


Replace flasher, replace blown fuses.
remove bulb and put another new one in, test.
remove bulb check socket for corrosion - wipe with dielectric grease if corroded. reinsert bulb test.
very carefully check all wires connected to back of socket -
look for break or splits --R&R.
Check the signal feed wire with a probe from the back of the bulb socket - go back along wire towards signal light relay. R&R
You can find diagram on the web if you need one.

Feb 17, 2015 | 1999 Dodge Ram 2500 4WD

2 Answers

ELECTRICAL PROBLEM


take it to a body shop

Nov 27, 2013 | 2000 Dodge Stratus

2 Answers

I have no break lights or turn signals


Turn signal tail lights and BRAKE LIGHTS NOT WORKING


It can be faulty brake light switch causing the problem or its blown brake light bulb. First check and confirm brake light lamp is working and that's not the case.

For turn signal not working it can be faulty turn signal switch or its issue with wiring:----


==========

To trouble shoot brake and turn signal related problem, check the help links mentioned below:-----


Click the link:----
1996 Buick Regal Grand Sport Brake light Switch Location? http://schematicsdiagram.blogspot.in/2012/04/1996-buick-regal-gran-sport-brake-light.html

-----------
No brake lights on Buick? http://schematicsdiagram.blogspot.in/2012/04/no-brake-lights-on-buick.html

----------
Brake lights not working on 1989 BUICK REGAL?

http://schematicsdiagram.blogspot.in/2012/04/brake-lights-not-working-on-1989-buick.html

-------
How to replace Brake light switch on Chevrolet Tahoe?

http://technoanswers.blogspot.in/2012/02/how-to-replace-brake-light-switch-on.html

---------------
How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html

----------
Upper brake lights work, but low brake light not working?

http://schematicsdiagram.blogspot.com/2011/12/upper-brake-lights-workbut-low.html

------------
1997 Cadillac Catera: How to replace Brake Light Switch?

http://howtobyme.blogspot.in/2012/06/1997-cadillac-catera-how-to-replace.html

------------


2003 Chevrolet S10 Tail light Fuse http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------
Chevrolet Parking light and Tail lamp light Wiring diagram http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------
Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------
Turn Signal Not working http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------
Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------
Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------
Turn signals not working on 1987 Jeep Wagoneer? http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

1996 Chrysler LHS brake light circuit wiring diagram?

http://technoanswers.blogspot.in/2012/02/1996-chrysler-lhs-brake-light-circuit.html

----------
How to replace rear Brake lights on 2004 Toyota RAV4? http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-rear-brake-lights-on.html

------------
One brake light on driver side not working, but other lights work?

http://schematicsdiagram.blogspot.com/2011/12/one-brake-light-on-driver-side-not.html

----------
2002 Lincoln Town car Fuse Box http://schematicsdiagram.blogspot.com/2012/11/2002-lincoln-town-car-fuse-box.html 2007 KIA Rio: Brake Light Fuse Box Diagram?

http://repairhelpcenter.blogspot.in/2012/06/2007-kia-rio-brake-light-fuse-box.html

-------------
Overhead Brake lights not working on 1999 GMC Sierra 4x4?

http://technoanswers.blogspot.in/2012/03/overhead-brake-lights-not-working-on.html

---------
2004 Ford Mustang: Brake light Fuse Location?

http://howtobyme.blogspot.in/2012/05/2004-ford-mustang-brake-light-fuse.html

---------

These will help.

Thanks.

Nov 24, 2012 | Cars & Trucks

5 Answers

2000 taurus left turn signal flashes rapidly and the left rear turn signal lamp does not work. Does ford have burned out bulb sense circuit that would give this indication? The right side flashes normally.


Yes - the fast flashing is a warning that a bulb is burned out. Change the bulb (be careful to put it in the same as the old one as it probably is 2 bulbs in one , parking and turn/stop) and you should be fine.

Jul 08, 2011 | 2000 Ford Taurus

2 Answers

Brake light and blinker on driver side does not work even after replacing bulb


I am assuming that the right (passenger side) turn signal light (blinker) is working fine. This will usually mean that the electronic flasher is not malfunctioning due to the fact that one side still works.

Since the right side brake light is working, I can also assume that the brake light switch is okay.

It is possible that more than one bulb may have been out. The quickest way to test this is to turn on the hazard lights and slowly walk around the vehicle. Make a note of which lights are flashing on one side of the car and compare that to the other side. One bad turn signal bulb (front or rear) is enough to prevent that whole side from blinking. It is also possible that a single bulb is responsible for both turn signal and stoplight. Make certain that the bulb that was replaced was not the back-up bulb. Replace all other bulbs found to be burned out.

And finally, check to see if there is power to the bulb socket. If it is a double-contact socket, there should be power to one of the contacts for "parking lights", while the other contact should be for "brake lights". Make sure the correct bulb was installed.

Apr 04, 2011 | 1997 Dodge Neon

3 Answers

On my dash cluster for a 2005 Dodge Ram 3500, I have a "Lamp Out" indication. My head lamps are working. Help Thanks


Hi
Turn on your lights,turn your turn signals on to either side and walk around the truck looking for a light burned out.Parking lights,turn signal,anything.If you don't find anything put your turn signal to the other side and walk around again.But most likely it's a parking or "running" light. The bulb out warning checks several different systems.Don't forget to have someone help you with back-up lights too.If it's time for 1 to go,there may be another.And have them step on the brakes and check those too.
Back-up and brake lights are 2 that you should never get a ticket for.
Seriously,how could you know?
You'll find it
Bob

Aug 15, 2010 | Dodge Ram 3500 Cars & Trucks

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

1 Answer

Left rear turn signal and brake light dont work


You have a broken wire to the turn/brake light portion of the light as they use the same wire. Or where the plug goes into the light assy could be bad. Torsion mount lights are horrible and you should think about replacing with a universal light that you can wire direct.

Feb 17, 2009 | 1997 Jeep Wrangler

1 Answer

Turn signal quit working


A lot of the bulbs that are used as turn lights have a 2nd filament in them that is used for parking lites and/or brake lights. Is there any part of that right side lights working? check parking lites and check brake lites.

The next thing to check is the flasher. Can you hear it clicking when you use it for the left side? Now try it for the right side. can you hear anything?


Oct 14, 2008 | 1995 Pontiac Grand Am

Not finding what you are looking for?
2002 Ford Mustang Logo

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...