Question about 2005 Ford Taurus

2 Answers

Check engine light 05 taurus

Filled up one day got mesg stating fuel level err gas gauge below e. Check engine light came on. Driving fuel gauge went to normal disconnected battery to get rid of check engine Next time filled up. Same thing happened took to advaned auto parts Error came to Fuel Sensor Error Curcuit Input Low What is that? Where is it located cant find it in the Haynes book for that car.

Posted by on

  • swestmpd Jan 07, 2009

    swestmpd@yahoo.com



    Hey I will try cap first then go from there and start looking.



    thanks I'll let you know if either is the case... helps alot..



    Scott

  • Anonymous Mar 12, 2014

    I ran my truck very low on gas then filled it up and then the check engine light came on and now it makes a gergling noise when u push the gas

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 35 Answers

From what I understand even a "qualified" Ford mechanic has problems locating this and if you look at a pre-2000 Haynes or Chilton manual it shows it being in a completely different location but to answer your question from what I understand (never changed one myself) it's on the passenger side, under the dash and should be by the radio. Should be held on by one or two screws. Also easy to get to if the radio is removed.

Posted on Jan 06, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem on my windstar.  It was an older model, but when I replaced the fuel cap it solved my problem.  apparently when there is even the smallest leak in a pressurized tank it sends the check engine light on.  Other than that, It might be an oxygen sensor.  
Hope this helps.  Tim

Posted on Jan 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codes p0463 and p0700


P0463 relates to circuit high input for fuel level sensor

P0700 Is a MIL request - control system for transmission

Feb 09, 2012 | 2005 Dodge Dakota

1 Answer

I have a hundai acent 2003 and a few months ago when i would fill up the tank of gas i had to do it very slow it would stop filling as if it was full when indeed it was not. Today i went to fill up and it...


a bad fuel level in the tank should not cause the tank not to fill up,but it can cause bad readings to the gauge. so the tank may have had more fuel in it than you thought and that is why it wouldn' t take the gas as it should. then when you filled up the next time the fuel level was correct so it filled up like you knew it was suppose to.I suggest you monitor the fuel with your trip odometer and fiil up every 200 miles to make sure the gauge is reading like it should or you may run out of gas.

Aug 07, 2011 | Hyundai Accent Cars & Trucks

1 Answer

My gas gauge is always on "empty." Even after I


Fuel level sending unit. that is the most common problem with these vehicles that cause the gauge to quit working

Jun 03, 2011 | 1992 Ford Taurus

1 Answer

My mom's 1995 Taurus has a fuel gauge that sporadically drops to below empty then after driving for awhile goes back to where it should be, a check engine light that stays on all of the time, and other...


possible fuel sending unit for the gauge check engine light try putting on a new gas cap.. sounds funny but if its the original and its bad it will trigger the check engine light wow i cant believe they told u to use a differnt gas b/s hope i helped good luck

Jan 22, 2011 | 1995 Ford Taurus

1 Answer

Our 2006 GMC Envoy's gas gauge started going up and down the last time we filled the tank. After driving for a while, it settled down and did fine. However, tonight when we filled it with gas, it started...


{: ) It is still safe to drive as long as you are aware you have enough gas for the trip. The problem is your fuel level sensor could be getting erratic and sending inaccurate signals to the engine control module, thus illuminating the check engine light at times. If you unexpectedly run out of fuel, thats when you will stall on the road. Better have it checked as soon as possible.

Nov 05, 2010 | 2006 GMC Envoy

1 Answer

When the fuel gauge reaches half or less, the check engine light comes on and stays on until tank is re-filled. Also when filling the tank, the station gas pump shuts off about 5 gallons before tank is...


Hi! You definitely have a problem on the fuel float thats why the check engine light is coming out. Please replace the fuel float and you'll be good. HOpe this helps and have a good one!

Jul 24, 2010 | 2001 Isuzu Rodeo

2 Answers

Po463 fuel level sensor circuit voltage too high. how to fix?


fuel level sensor is part of the fule pump assembly. code is telling you sensor is malfuctioning. do gauges work? if yes i would leave problem alone till you need a fuel pump

Feb 23, 2010 | Isuzu Rodeo Cars & Trucks

1 Answer

GMC envoy after I filled gas tank the low fuel light came on and as I was driving it would go off than come back on after a few miles the check engine light come on stayed on and the low fuel light still...


You will need to replace the fuel level sensor which is in the fuel tank.They have a lot of problems because the metal fingers on the sensor wear off and gives you the incorrect readings.This will also cause the check engine light to come on.You will probably have a level sensor code.This will be a lot easier if the fuel level is down to about a quarter tank or less.Also you should be able to get just the level sensor and not have to get the complete fuel pump module.Good luck.

Dec 02, 2009 | 2005 GMC Envoy Xl

Not finding what you are looking for?
2005 Ford Taurus Logo

522 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...