Question about 1991 Honda Prelude

1 Answer

What is wrong with my honda prelude 91 when i'm driving it and the steering wheel shakes and make noises

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 226 Answers

Bad bearings in the hubs can cause it try changing your hubs (hubs are sealed units when the grease in them dry out you need new 1's)

Posted on Jan 06, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Front Suspension noise

From your description,I suspect worn tie rod ends.The tie rods connect the steering gear to the wheels.grasp the tire rod while you or an asistant shakes the wheel from 3 o'clock to 9 o'clock to pin point where it's loose. could be inner or outer ends or both.

Jan 24, 2013 | 2008 Honda Civic 1.8

1 Answer

Noise and vibration from right side wheel area.

Sounds like a possible wheel bearing failure. Jack that wheel up and grab the tire at the top and bottom and shake/yank it hard - you should have basically no movement out of it. If you shake it and find looseness, that's a bad wheel bearing.

Mar 20, 2010 | 2004 Honda Civic

1 Answer

How do i disconnect the 4ws

Compare your rear knuckles to a non 4WS. You have to remove the steering extension shaft leading back there as well as the rear tie rods. The rear knuckles have to be locked so they don't steer. Might need to swap some of the components from a junkyard 88 89 90 91 Prelude.

Dec 09, 2009 | 1988 Honda Prelude

1 Answer

I need a diagram of the front suspension and sway bars 91 honda

if its noisy, something is bad wrong. lift it up and have one your kidsturn the steering wheel and look for anything loose. I would not have purchased any car that had been hacked like that. ck ball joints, ck for any loose bolts, ck everything you can see. dont drive it intil you find and repair what is wrong. without knowing what is wrong, i would say it coulld be dangerous.

Sep 23, 2009 | 1991 Honda Accord

2 Answers

Shaking steering above 60mph

First we need to know where is the shaking noise coming from?Is your car a 4X4?If noise comes from a driven wheel it can be the differential system or bearing also.Usually the speed you have specified is pointing to wheel alignment problem.Also can advice to go to a different tire shop and check wheel alignment again,also ask the mechanic to check the state of your wheels and tires.One of them may be damaged .

Jul 17, 2009 | 2006 Honda Odyssey

1 Answer


Usually the indication is around corners the CV joint will make a popping sound. You can also tear the boot on the CV joint, but my theory is just to drive it until it makes noise. No sense in changing it when there is still life in the old one.
Really the only thing that goes wrong is the CV joint portion of the shaft wears out, except accidents and other unforeseen instances.
You can buy lifetime warranty axle shafts from Auto Zone or Advance and those kinds of parts stores.

Feb 11, 2009 | 1991 Honda Prelude

3 Answers

Wheel bearing?

If it is a howling noise it is most likely your bearing (kinda sounds like an airplane)

You should also check the tires for broken belts and bulges. As well as that they are properly balanced.

Jan 06, 2009 | 1991 Honda Prelude

2 Answers

1989 Honda prelude makes a clicking noise when turning

Sounds like it an outer cv joint on that side. They start making a ticking noise under load and it gets worse as time goes on. Have a shop look it.You'll need a pretty well stocked tool box if you want to do it yourself.

Nov 29, 2008 | 1988 Honda Prelude

3 Answers

Rattle in front right 98 prelude

Does your vehicle have hub caps if so check to see whether all the clips are ok.
push up and down on each corner and to see if you can hear the noise, it could be a number of problems, ie shocks, bushes, wheel bearings or the bump stops in the shocks.
also jack the car up and check the steering components by wiggiling the wheel left to right looking for excess play and check the CV shafts and boots, usually if the boots are damaged the CVs will either need re greesing or replacing.

Sep 29, 2008 | 1998 Honda Prelude

1 Answer

1991 prelude drivetrain problem

Wow, that's weird! If the speedometer is moving, but you aren't, then yes, something in the axle is not connected to the wheel. Were there any weird noises or symptoms before this happened? Either the cv joint is completely shot (u should have heard noise when turning a long time before this) or the spline could be stripped, but that is something I haven't heard of. If the clutch was shot, the engine would rev, but speedo is connected to transmission, so the speedo would not work if the clutch didn't. Let me know if anything was going on before this happened, I have a 91 Prelude (2nd since 1994, love it). countrycurt0

Sep 16, 2008 | 1991 Honda Prelude

Not finding what you are looking for?
1991 Honda Prelude Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides