Question about 2002 Mitsubishi Lancer

1 Answer

I need to check my tranny fluid, but????

So, how do I check my tranny fluid??? While the car is running before after?????? HELP. My auto transmission is slipping from 3rd to 2nd so I'm hoping that is the problem.

Thanks.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

You should check your fluid after you have driven it for a bit (to make sure the fluid is warm). Also leave the vehicle running after you have driven it. Good luck and I hope just some fluid will fix your problem. Thanks for using fixya!

-JC

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Toyota Camry what kind of automatic transmission fluid does this car take


Check tranny fluid level. If at correct point new oil or adding will not correct anomaly. Need tranny pro to resolve issue.

If you need to add a little standard auto transmission fluid will do the trick. Nothing special.

Jun 06, 2016 | 2002 Toyota Camry

1 Answer

1988 chevy 4x4 k1500 auto tranny wont shift into 2nd, 3rd etc


Check the sensors on the transmission. May just be corrosion on the sensors or it may be a faulty sensor. Also, the torque converter bearing may have went bad due to the running it on low transmission fluid.

Feb 23, 2014 | Cars & Trucks

1 Answer

Transmission problems ... It down shifts too hard


Check fluid level worse case gears aren't sincrenizing properly tranny shop can tell u that when they check fluid level but sounds like tranny going out or your clutch if has one I'd say clutch first before tranny gears if manual tranny if auto then fluid or tranny needs serviced

Feb 21, 2013 | 2007 Honda Odyssey EX

2 Answers

My 2000 concorde runs great when cold then tranny slips when hot. . . . . ?


Fluid level ok? Check it when hot and car running.

Have you had the tranny serviced recently?

This type of tranny uses the Dextron +4 fluid, any other fluid would mess up the transmission.

I have a 1999 Intrepid, no problem w tranny, but a month ago I put an aditive that a friend recomended. After only about 5 miles I felt the car more responsive and with more power. I also think my gas mileage improved.

I got it at AutoZone the brand is RISLONE Transmission Stop Slip with Leak Repair
it says works with all types of fluids.

I hope this will help. Good luck

Mar 02, 2010 | 2000 Chrysler Concorde

3 Answers

Where are my transmission sencors my car dosent shift right can u post a picture


there inside the tranny you have to remove the pan to see them but thats not going to be your problem go buy a can of TRANSX first!! and try that if that helps then you need to plan on rebuilding your tranny or replacing it

Jan 14, 2010 | 2003 Ford Focus

2 Answers

How do I check my tranny fluid on my 01 Subaru Impreza?


I assume you have the 4 speed auto and that it is red auto transmission fluid which is leaking.

You obviously have a leak from the transmission itself, or from a transmission fluid hose, which must be identified and fixed urgently. The leaking fluid is no doubt coming into contact with the hot exhaust system (often by blow back) which will give you a burning fluid smell.

You must ensure you check the transmission fluid level immediately and top it up with the correct spec fluid. Otherwise the transmission will malfunction if very low on fluid and you will potentially damage it.

You need to need to get the vehicle to a Subaru dealer for service or to a competent/reputable auto transmission specialist to have the leak identified and fixed as soon as possible.

Sean

Dec 19, 2009 | 1995 Subaru Impreza

2 Answers

Need to find transmission fill cap so I can fill it with fluid


you either have to fill it through the transmission dip stick if it is equipped with one, or you need tho crawl under the car and look at the side of the transmission and you should see a plug looking bolt which you will have to remove and fill through there till it runs out that plug hole

Nov 15, 2009 | 1999 Isuzu Rodeo

1 Answer

Auto transmission slips then grabs


first thing i would try is changing the transmission fluid out and filter, i beleive its almost 8 quarts. use a full quart of lucas transmission additive with the new fluid. if this doesn't help, the transmission will either need replaced or rebuilt

May 24, 2009 | 1996 Ford Probe

2 Answers

My check engine light came on on my 2002 jeep grand cherokee, we took it to auto zone to have it check with their computer and came out with the following explanationbb6 overnor pressure sensor offset...


Don't flush the transmission. Remove the transmission oil pan and replace the governor pressure solenoid and switch. Reinstall the pan and add fluid. Disconnect the battery for a few minutes and reconnect to clear any codes and road test.

May 07, 2009 | 2002 Jeep Grand Cherokee

1 Answer

1985 Mercedes 190E auto tranny swap - wont go into gear


are you checking tranny fluid level.check condition of fluid if it look brown smells change tranny fluid and filter.fluid change dont help .you got pump and input clutch problems.

Apr 28, 2009 | 1985 Mercedes-Benz 190

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...