Question about 1999 GMC Sonoma

1 Answer

Where is the starter or silanoid.my truck will not turn over?

1999 gmc sonoma

Posted by on

  • Anonymous Mar 16, 2014

    Starter gets power but will not turn over

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

Located on the transmission bell housing usually on the bottom drivers side.
Thanks for using fixya!

JC

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1999 gmc sonoma which I recently had clutch replaced however it still won't go into gear. Any suggestions as to what else it cold be?


did you have it pro replaced? If so, you should take it back to them. How long is your warranty? If you personally replaced, you need to check the service manual. Here is the owner manual

1999 GMC Sonoma TSBs CarComplaints com

and you may find this info about clutch issues here
How to Adjust the Clutch on 1997 GMC Sonoma eHow

Jan 10, 2015 | 1999 GMC Sonoma

1 Answer

Replacing starter for gmc sonoma


You will need to remove the motor mounts and jack up the engine and remove the passenger side tire to be able to get it out. the starter is only 2 bolts. Not hard just time consuming. Disconnect the battery before starting the process. The bolts on the starter are easily accessable you will have to raise engine to be able to get it out.

Jun 05, 2011 | 1999 GMC Sonoma

1 Answer

How do you change starter on 95 gmc sonoma?


4 cyl or 6> 4 cyl must remove the exhaust at manifold then the bar from engine to tranny then starter it is a tight squeeze

Jun 30, 2009 | 1999 GMC Sonoma

2 Answers

1999 GMC sonoma starte installation


2.2L Engine remove protective shields as needed then remove front exhaust pipe. Remove the brace from the engine to the clutch housing, then disconnect starter wiring. 4.3L Engine 2 wheel drive just remove the right front tire and you will have access to the wiring. 4.3L Engine 4 wheel drive you must remove the differential carrier shield if equipped then remove the starter bolts and rotate the starter to get access to the wiring. Good Luck.

Jun 15, 2009 | 1999 GMC Sonoma

1 Answer

How to change my starter on a 1999 Chevy P10 Step Van


Remove the negative cable from the battery.
Remove wires off of starter.
Remove 2 starter bolts.
Reuse shims that may be installed.
Replace the starter in reverse order.

Jun 09, 2009 | 1999 GMC Sonoma

2 Answers

99 gmc sonoma starts sometimes and sometimes it doesn't


Check and clean your battery cables. Then, trace the wires from your battery to your starter. Make sure they are clean and secure. I believe this will fix your problem. If not, you may have a starter solenoid starting to fail.

Hope this helps and good luck!

Jan 13, 2009 | 1999 GMC Sonoma

Not finding what you are looking for?
1999 GMC Sonoma Logo

Related Topics:

824 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...