Question about 2001 Dodge Durango

2 Answers

Have a burnt out front headlite on a 2001 dodge durango and i can't seem to get at it from the backside. does it come out the front so u can change the bulb????

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

3 10mm screws, 2 just above bumper, right below lens and 1 above lens below hood, one good tug to get ball end out of retainer clip and your good bulb # is 9007

Posted on Apr 11, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Yes you take it out from the front if not you reach down to the back of the light under the hood sqeece and turn it

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Dodge Durango with burnt AC compressor, can I bypass with belt without removing compressor?


no because you will need to install a idler pulley off a non air engine to make things work or you may be able to buy a belt for a non air dakota that wiill work on your dorango as they both have the same power trains

Dec 17, 2012 | 2001 Dodge Durango

1 Answer

What's your problem?turn signals stoped working on 2001 dodge durango


I would look for bulbs being burnt out on the turn signals, or the flasher is bad.

Nov 06, 2011 | 2001 Dodge Durango

1 Answer

What is MIL code 1757 on 2001 Dodge Durango?


governor pressure above 3psi in gear with 0mph
possible causes
solenoid pack connector 5v supply circuit open
sensor signal circuit shorted to ground or shorted to voltage
governor pressure sensor defective
transmission fluid burnt or pan has debris
valve body valve sticking or defective
pcm defective

Jul 13, 2010 | 2001 Dodge Durango

1 Answer

2001 dodge durango..rear air not working, front


u could have bad control modular,,have him ck that,,

May 28, 2010 | 2001 Dodge Grand Caravan

1 Answer

How do you put a 2001 dodge durango in neutral to dolly tow it. I know to put the transfer case in neutral but can't seem to shift the transfer case into neutral, 4h and 4L and awd shift


If your going to put the front wheels on a dolly then it won't matter whether or not the front end is in neutral,if the rear is going to be lifted then it is a good idea to remove the drive shaft,this will keep the transmission from turning.

Apr 05, 2010 | 2001 Dodge Durango

1 Answer

2001 dodge durango 4 wheel drive not working loud knocking


You need to check the cv joints in the front end or the u joints in the front drive shaft.If none of the above then the problem is internal in the front diff.

Jan 28, 2010 | 2001 Dodge Durango

1 Answer

Change front brake pads on 2001 dodge durango


Front, remove the hold down clip, should be a 7mm or a 45 torx bit to get the slider pins out. If you are not sure what you are doing, please spend a little money and have a pro do it for your safety, and the safety of others around you.

Mar 18, 2009 | 2001 Dodge Durango

1 Answer

2001 dodge durango turn signals


HAVE U REPLACED THE TURN SIGNAL FLASHER? IF NOT DO SO, THIS SOLUTION ASSUMES THE TURN SIGNAL LIGHTS ON THE FRONT AND BACK ARE LIGHTING UP BUT NOT BLINKING.

Feb 09, 2009 | 2001 Dodge Durango

Not finding what you are looking for?
2001 Dodge Durango Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...