Question about 2005 Ford F-150

1 Answer

Brakes am changing brakes and rrouters what is the best way to change these

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 139 Answers

All you have to do is take the calipers off crack open the bleeder of the side you are working on leave the old pad in the caliper and press the pad in as far as it will go tighten bleeder clean the rotors with brake clean to get the oily substance off they put on during shipping to keep them from rusting put rotor back in place and put new pads in caliper if they give you grease for the caliper sliders put some on the caliper bolts and sliders the thing the bolts go into on the caliper so they move fairly easy this way your brakes will work better and last longer put caliper back in place tighten caliper bolts snug usually with a ratchet like a good 3/8 ratchet then do the other side fill up the master cylinder with proper brake fluid usually dot3 but should say on master cylinder cap bleed brakes if you did just the front bleed the passenger side first pump pedal a few times dont go all the way to the floor have someone open the bleeder on the right front passenger front while holding pedal down with just a little pressure one foot on pedal one under pedal so it dont go to the floor then do the same for the other side check fluid start vehicle if pedal is good go for a test drive and thats it.

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 chevy Silverado 1500. brake lights recently stopped working. I have tail lights though. I have checked all the wires, checked and changed all fuses, changed all bulbs, and even changed the...


Hi Eric, I don't know but it could be the computer most of the times is down the left side with the steering wheel on the right (here) with the fuse box near the steering. All the best with it. Greg.

Feb 19, 2015 | 2002 Chevrolet Silverado 1500

1 Answer

What gets done at 60 000 service intervals for petrol engines


This is best answered by the service schedule of the car. Any car of the same make around the year of manufacture will have the same schedule. IF it is miles you are referring to then items like cam belt change, auto oil change, brake fluid change, coolant change brake rotor check, cv joints would most likely be on the schedule as 60.000 miles is a big service.

Oct 01, 2014 | 2007 Opel Corsa Utility

1 Answer

How do I change front left brake hose on 2006 Pontiac g6


Remove the wheel,take the caliper off like you would do to change the brakes,follow the brakeline up to the master cylinder,unscrew it, go back down to the caliper and remove the bolt holding it to the caliper.( its best to drain the brake reservoir before you do this. Bleed the brakes when you are done)

Aug 06, 2014 | Cars & Trucks

1 Answer

I am changing the front brakes on my 1995 Chev. S-10 (with ABS) When I changed the pads and put the caliper back on, and pumped the pedal to bleed the brakes, it seemed to have locked the brakes. Is...


Unfortunately it takes special equipment to bleed the brakes on a vehicle with ABS brakes. If you can get the car to a shop it's best to have them bleed the air out of the system.

Feb 21, 2011 | Chevrolet S 10 Cars & Trucks

1 Answer

I have to change the break fluid but i dont know where its located


Why does the brake fluid need changed? This service is usually only needed on much older cars...Has your Van been parked for a long time? Is your brake fluid contaminated? Best guess would be someone filled the brake reservoir with something other than brake fluid...If so, this is a repair for a brake specialist...:)

Dec 15, 2010 | 1996 Plymouth Voyager

1 Answer

Changing Brakes concern


Most brake pads have what they call squeak indicators.These indicators will start squeaking when your not applying the brakes when the pads get low.Otherwise the best way is to inspect the pads and see how much is left.

Mar 06, 2009 | 2001 Volkswagen Beetle

1 Answer

99 dakota back brakes


Ask your mechanic to back off on the adjustment ( way too tight ). Or maybe, did you accidently leave the parking brake on? ( happens to the best of us!!! ). Good luck and God bless.

Jan 21, 2009 | 1999 Dodge Dakota

Not finding what you are looking for?
2005 Ford F-150 Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...