I have a 2000 pontiac montana. I have just recently replaced all parts related to the cooling system. My overheating problems are gone. I also had the plugs and wires changed. Now it has a miss in it. I never know when it is going to happen. It chugs on the motor and won't allow you to give it any gas. You have to stay at a steady speed until it lets go. When it does finally allow you to give it gas it takes off like you had your foot all the way to the floor. Could this be my fuel filter, fuel pump, egr valve, or a vacuum problem?
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your listing shows a 2000 Pontiac Montana...your question relates to the Mercedes? On the Pontiac, there are only 2 wire connectors to the engine starter motor...They use different sizes to match the connecting wires...
No, but the belt may have struck the crankshaft sensor. The sensor is behind the crankshaft pulley. Check the wires going back to the sensor and repair as needed. Let me know if you have more questions.
first thing, change the thermostat. this should fix the overheating problem. Your hot coolant goes from the engine to the radiator core, then back to the engine. If your thermostat is stuck shut, you will overheat. try this first, and let me know, If you still have problems, We will get it fixed. hope this helps
Yes,You need to bleed the air from the cooling system,use the bleed valves,one is near the thermostat,and the other is on a pipe sticking up toward the front of the engine,make sure there is enough coolant in the system,and start and run the engine when it gets warm,not hot,open the bleeder near the thermostat,and watch for coolant,and air to come out,leave it open about 10 to 25 seconds,then close it and wait about 3 minutes or so,and bleed the other bleeder.You may have to repeat the process more than twice,and keep the coolant reservoir full.If this was helpful,please rate,thank you
How do you know the thermostat is ok? If in doubt replace it. Water pumps are a even bigger what if. Did he do a radiator flush? Cooling system flush of the engine? Cooling fans come on at what temp and go off when? Replace the engine temperature sensor? 6 years old is bound to have sensors and such go bad.
tran should be ok need to take head to repair shap and be sure head is ok and not cracked. thermostat, radiator, or cap, hoses need to be checked to dtermine what caused it to run hot also check engine fan. Pls rate this solution
I have a 2000 montana and mine was doing the same thing. I replaced intake manifold gaskets, thremostat, and water pump. Turns out it my heads were warped. I had them taken to a machine shop and it has seemed to fix my overheating problems.