Question about 2001 Chrysler Town & Country

1 Answer

My van wont start

Hey it looks like you know what your talking about!
i switched the relays and it started for about 15 seconds but would not stay runing when i let off the gas??

Posted by on

  • blueyedsinne Jan 07, 2009

    hey,it starts now sometimes.i turn the key and nothing happens several times until it finaly starts??

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

What has happened is when you switched the battery the computer lost its memory.. once you get it started keep the rpms up and go for a drive it may take up to 5 moles of driving before everything is relearned. then it should idle fine

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Threewarning lights stay on when i try to start my van abs, anti skid andtraction control then my van wont turn over.its not a battery fault because my lights still work.any ideas ?


Anti-theft system ! Do you have a security light on as well ? What make , model an year vehicle ? Do you know if your vehicle has a starter relay ? Park neutral switch . Do you know how to do automotive electrical testing ? Find a wiring diagram for the starting system on your vehicle ,see what is all involved . You can find a wiring diagram here http://www.bbbind.com/free_tsb.html free wiring diagrams ! The starter relay is energized by the PCM/ECM engine computer ,this sends B+ voltage to the S terminal on the starter solenoid ! If you find the starter relay an pull it out of it's socket an look on the bottom of the relay , you should see four numbers . 30,87 , 85,86 . Go on youtube an watch video on relays , how they work an how to test . There is a good 1 from scanner Danner on GM fuel pump relay how to test , I know it's not the starter circuit , that's ok it works the same way . VEHICLE RELAYS Operation Diagnosis

May 01, 2016 | Cars & Trucks

1 Answer

2007 ford e350 van fuse for fuel pump location


Fuel pump relay or a FPDM - fuel pump driver module , or the inertia fuel cut off switch was tripped . F150 Expedition No Start P1233 Fuel Pump Driver Module How to test an electric fuel pump no fuel psi testing Ford

Battery junction box , under hood ! Fuse # F13 20amp. The fuel pump relay is in same box . Do you know what a relay is ?

Mar 24, 2016 | Ford Cars & Trucks

1 Answer

Put on new fuel pump got pressuer but want stay cranked


Your post is lacking any detail. However, if you are stating that the engine starts after being cranked but dies out (wont stay running) there are 2 ways the fuel pump is activated. When the key is first turned on, there is a 5 second fuel pump run (the ECM energizes the fuel pump relay). After the engine starts, the fuel pump relay will only stay energized when the oil pressure switch closes keeping the fuel pump relay on (oil pressure is above 5-7 psi). If the oil pressure switch is faulty or there is no oil pressure, the engine will stall just after starting.

Apr 10, 2014 | 1999 Chevrolet Astro

1 Answer

Remote starter for Chrysler town and country


I posted this earlier.. charge it up and look for low voltage from the alternator when idleing..if its not charging right it wont run right,,

Dec 08, 2013 | Chrysler Town and Country Cars & Trucks

1 Answer

Location of fuel pump relay switch in 1992 olds silloutte 3800


It is under the Hood, in the Fuse Box. Go to this web site and put in your information and you will see the diagram

www.bbbind.com

Apr 15, 2013 | 1992 Oldsmobile Silhouette

2 Answers

1997 GMC Savana 5.7 L conversion van. Cranks but wont start


look under the hood on the right side where your brake fluid is..There is a black box to the farest right of the brake fluid. take off the lid to this box were you will find fuses..Reach in and feel the fuses to see if any are loose.The largest fuses in the front, push down on those and then try to start it up..Take them out look at them make sure there ok if this dont work..they the one bad might need to be replaced..

Nov 17, 2009 | GMC Savanna Cars & Trucks

1 Answer

1990 daytona still wont start


Automatic or manual shift ?

Automatic:
Check for power from the starter relay. Yes / No ?
Check for power fronm the ignition switch. Yes / No
Did you replace the neutral safety switch. Yes / No

Did you buy or borrow a REAL factory service manual ? Get one.

Mar 19, 2009 | 1990 Dodge Daytona

1 Answer

Chevy astro van turns over but wont start when


Check to see if the fuel pump is kicking in,
when you turn the key on without starting the van you should hear it kick on for about 2 seconds,

It could be...
A clogged fuel filter...
Blown fuse for the pump..or bad pump relay..
No gas
Bad fuel pump

Mar 07, 2009 | 2000 Chevrolet Astro

2 Answers

1985 conrvette


poss. is fuel pressure reg. problem. put a guage on the test port and check press. should be above 35psi. see if it stays running when you spray choke cleaner in the pcv valve steadily while starting. if the engine stays running after a few seconds of running on choke cleaner then probably a bad fuel pump relay cause the oil pressure switch will keep the pump on without the relay when it has good oil pressure.
let me know if ya can do this or if it helps.

Jul 04, 2008 | 1985 Chevrolet Corvette

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...