Question about 2006 Honda Accord

1 Answer

I just replaced my battery in my 2006 honda accord with a new battery. Now the car will not start! Is there a sensor or a reset button????

Posted by on

  • 1 more comment 
  • sford400 Jan 21, 2009

    My son has a similar problem. Battery got drained, then jump started. With a full battery charge now, it turns over, but won't start.

  • tonymc01 Feb 20, 2009

    new battery installed. Power has drained out of battery over a period of a week. No life in car now. Alternator tested and it was charging battery. Something draining battery

  • jface May 11, 2010

    Where did you buy the battery? Is it new or recharged? Either way check to make sure it is fully charged. Autozone has the equipment.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 50 Answers

Hi there. When you purchased the battery was it supplied to you as dry cell battery? If so, was the battery filled with distilled water and left for at least 30 minutes to become effective/charge? If the battery was purchased (wet) already filled with distilled water, is it fully charged, effective and ready to go? When you say the car will not start, is the engine cranking over at full speed? If it is, then we need to consider quite a number of points. Firstly, are you absolutely sure the correct specification of battery is fitted and are the positive and negative terminals exactly the same and the right way round? If so, firstly, to ‘reset’ everything, switch off the ignition (in fact remove the ignition key) disconnect the battery for at least 5 seconds and then reconnect the battery. Then try starting the car. If the car does not start you then need to view if the PGM-FI ECU has any fault codes flashing. If there is a code showing, I’m afraid to say that you will need to seek the help of a Honda Dealer. Hope this helps get you started. Scottech.

Posted on Jun 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I disconnected battery from 06 honda accord now my display shows error when i try to use it.

some vehicles require you to keep power all the time, so when u changed the battery you should of connected the new one via jump leads before removing old 1, you have lost the memory & it now needs resetting something only a garage can now do, but check internet in case there is a hidden reset you can access when u turn ignition, usually holding down a button till a hidden menu pops up.

Jun 08, 2015 | 2006 Honda Accord

1 Answer

What is P0344 code for Honda Accord 2006 model car

P0344 = Camshaft Position Sensor 'A' Intermittent Interruption

Possible causes:
- Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery

Oct 10, 2013 | 2006 Honda Accord 2.0

1 Answer

I have92 Honda accord ex I can push start run great wont start with key new battery and new starter and fuses and relays what could be wrong

ignition switch is worn out its under dash on steering colum either install push button to start or replace also if its standard check clutch pedal sensor

Feb 16, 2012 | 1992 Honda Accord

1 Answer

2006 honda accord would not start. All the lights

Cold weather is taking it's toll! Sounds like the battery is weak.......

Feb 13, 2010 | 2006 Honda Accord

1 Answer

I have a 2006 Honda Accord. I put the code number

radio needs reset again.remove negative battery cable for 5 minutes,reattach.this will reset turn on radio and enter radio code.

Oct 17, 2009 | 2006 Honda Accord

1 Answer

2006 Honda Accord was serviced but oil life light is flashing at -17

It means they didn't reset the oil change light. It means it's 17 miles past due and counting.
To reset, hold down the reset button for about ten seconds until everything in the display starts flashing.
Then while it's still flashing, hold down the reset button again for ten more seconds until the oil life says 100%.

Then, your all done. :)

Apr 19, 2009 | 2006 Honda Accord

2 Answers

2006 honda accord, after changing the battery. resetting the radio code. the radio will not pick up any stations???

Unless the Accord was jump started, creating possible power surge to damage radio, it should not of had any relationship to the radio.

But, just in case, would suggest disconnecting battery for 5 minutes, reconnecting battery, reentering radio code and see what happens.

If that fails, hopefully your under 36k miles or got the Factory extended warranty "Honda Care" Service plan, so take to the Honda Dealership to see what they say.

Mar 10, 2009 | 2006 Honda Accord

1 Answer

Resetting the navi and radio codes 2006 accord

The Owners Manual walks you through it step by step.

If your missing the manual, swing by your Dealerships Service Drive, most Service Advisors would be happy to show you how to do it.

You can also order a new Owners Book at directly, even have it mailed to your home. If you order it at the dealership, they get it from the same place, mark it up and you have to go get it yourself.

Jan 13, 2009 | 2006 Honda Accord

1 Answer

Sensor malfunction in honda accord 2006

its not the battery 60 amps is its capacity not what it puts out only capable of putting out which sensors are causing the problem according to obd 11 as when you change a battery on hondas the ecu has to re-learn all the setting and your car will run erratic and cut out till it learns the codes don,t forget the sensors don,t come into play till the engines warmed up so you need to take it for a run and keep it at a contant 50 miles an hour for a while let your foot off the gas see if it stalls do this a few times if it does stall obviously if this doesn,t cure the problem take note of the sensors that the obd has thrown up

Sep 16, 2008 | 2006 Honda Accord

Not finding what you are looking for?
2006 Honda Accord Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides