Question about 2004 Chevrolet TrailBlazer

2 Answers

Door locks automatically

We got a Chevy Trailblazer 2004. It is nice. When I turn the engone on the doors automatically lock. My wife doesn't like that. Is there a way to overide this, or changed to manually lock the doors? Thanks.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

You can change the driver settings by using the lower right controls on the steering wheel. i have mine set to lock when you put the truck in gear

Posted on Jun 02, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 404 Answers

Is there a disable switch on the dash

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to pop hood from outside of 2004 chevy trailblazer


You cannot release the bonnet from the outside.

In any case the key should open the driver's door manually. You will need to turn it either once or twice in succession. If it will not open then pull on the handle and turn the key in the lock at the same time.

Dec 20, 2015 | 2004 Chevrolet TrailBlazer

1 Answer

How to pop hood from outside of 2004 chevy trailblazer


You cannot release the bonnet from the outside.

In any case the key should open the driver's door manually. You will need to turn it either once or twice in succession. If it will not open then pull on the handle and turn the key in the lock at the same time.

Dec 20, 2015 | 2004 Chevrolet TrailBlazer

1 Answer

How program my keyless entry remote for my 2003 chevy trailblazer


1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.

4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).

Mar 20, 2012 | 2003 Chevrolet TrailBlazer

2 Answers

Power door locks on a 2004 chevy tahoe don't work


The door locks on my 1999 tahoe stopped working and I checked the fuse, which was fine. The problem turned out to be that the fuse for my cigarette lighter was bad and for some reason it also must be working in order for the door locks to work. Put in a new cigarette lighter fuse and the door locks worked again!

Jan 19, 2010 | 2004 Chevrolet Tahoe

2 Answers

When i open my drivers door my radio and dash lights stay on but they turn off when i open the other 3 doors ???2003 trailblazer


The door sensor needs adjusting. It may be loose.
Loosen the lock nut on the pushbutton sensor in the door frame.
Unscrew the sensor a little and re-tighten the lock nut.

Oct 12, 2009 | 2003 Chevrolet TrailBlazer

2 Answers

2004 Chevy Trailblazer - Randomly the liftgate does not unlock. Have to crawl in the back and manually release the lock through the small access hole. Doesn't seem to matter how many times I cycle through...


That's one of those thing you will need to look at. check the electric solenoid to make sure it has a good ground and "hot" connection. Also make sure that the lock mechanism is operating freely and not binding.

Jun 21, 2009 | 2002 Nissan Altima

1 Answer

Driver door panel not working.


Check for broken/dmaged wire(s) in loom that goes from post to door in hinge area.

Apr 28, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

2004 chevy trailblazer door lock remotes


The body shop should be able to program the Key F.O.B back to your vehicle. If the battery was disconnected the reciver to the F.O.B lost the frequency.
If the shop can not fix it the dealer can.

Jan 27, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...