Question about 2000 Ford Windstar

Open Question

2000 ford windstar SE TV unit fuse or power ?

I have a 2000 Ford windstar SE, and this car has an VCR enterteinmet unit locate it at the mittle of the two seats at the front... I would like two know where is the power of this unit come from or is it has a specific fuse I got to check. Because I check all fuses from the front box and  under the hood and it seems that all of them are good. Where should the power come from?

Posted by on

6 Suggested Answers

  • 7 Answers

SOURCE: Ford Windstar SE, 3.8L V6, 1999, front seat heat/defrost is cold

the blendor actuators strip out the gear inside the actuator cases on these all the time. replace the actuator.

Posted on Mar 19, 2009

  • 116 Answers

SOURCE: 1998 Ford Windstar Transmission to 2000 Ford Windstar

while it is possible to perform that swap, the newer 2000+ transmissions will have updated internals and such.

so will it work............. yes.

is it optimal.................no.

Posted on Apr 11, 2009

  • 47 Answers

SOURCE: where is the solenoid located in 98 ford windstar,

the solenoid is attached to the starter and if somebody told you have to be replaced,is cheaper and quick to replace the starter

Posted on Sep 17, 2009

Testimonial: "thank you for your help!"

SOURCE: 2000 ford windstar gas smell on the inside only no

I had this problem a few years ago with my 1998 Windstar. It would only happen when the rear was loaded, e.g. when I had passengers in the middle or back seat. When it was just the driver and a front seat passenger, no gas smell.

The problem was a bad seal at the top of the gas tank. The extra weight over the rear of the van tipped the body enough to have a little gas leak from a full tank.

Unfortunately the fix cost about $300, mostly labor to remove the tank, fix the 29 cent gasket, and reinstall the tank.

Posted on Mar 13, 2010

cobra777
  • 80 Answers

SOURCE: need fusebox diagram for 1999 Ford Windstar SE



ef07f16.gif 342512b.gif


4cdb386.gif


58765ab.gif


Hope this helps.. :-)

Posted on Jul 21, 2010

leedavidian
  • 1420 Answers

SOURCE: fuse relay diagram under the

Welcome to FixYa.com

7bf1a7a.png5a869a1.png

Thank you for using FixYa.com, Regards, Lee Davidian


Thank You for using FixYa - a 4 THUMBS- UP rating is appreciated for answering your FREE question!!!!!

Posted on Sep 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing rear ac panel on 2003 ford windstar se model


A few retaining screws and with the back row of seats removed it just snaps off the inside of the van.

Oct 27, 2016 | 2003 Ford Windstar

1 Answer

Location of crank position sensor for 1999 ford windstar 3.8 se


Crankshaft position sensor is mounted on the engine front cover next to the crankshaft trigger wheel, below electronic ignition coil pack on transmission housing .

Mar 29, 2014 | 1999 Ford Windstar

1 Answer

Repair front directionals, hazards and high and low beams 2000 ford windstar


You probably have lost your ground. Check ground straps going from firewall to engine block. Then follow through and verify at the lights and look for exposed or corroded wires.

Jan 15, 2014 | 2000 Ford Windstar

2 Answers

There is a small tube leaking out of my firewall on my 2000 ford windstar se it is antifreeze is it my heatercore


if its colored and smell its antifreeze so its the heater core, if its clear like water then its just condensation from the evaporator and that is normal

Aug 17, 2010 | 2000 Ford Windstar

1 Answer

2000 ford windstar 3.8L Front heater has


what stopped? the air doesnt blow,if thats the case then replace the blowermotor resistor, its located on heater box on passengerside next to blower motor.hope this helps, let me know if this was the problem.

Dec 24, 2009 | 2000 Ford Windstar

2 Answers

Fuse Diagram for 2000 Ford windstar


here is a link to where you can down load a owners manual to help you
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Mar 21, 2009 | 2000 Ford Windstar

1 Answer

Ford Windstar SE, 3.8L V6, 1999, front seat heat/defrost is cold


the blendor actuators strip out the gear inside the actuator cases on these all the time. replace the actuator.

Mar 10, 2009 | 1997 Ford Windstar

1 Answer

Vcr


If the system is the one that was factory installed, it does not need cables. The VCR slides into the console and makes it's connection via a connector on the bottom of the unit. The connector panel that is on the rear of the console, facing the rear passenger seats, are there to allow you to plug in a DVD , video game, or MP3 player. If your Windstar has the remote control, it is easier to program, but you can program everything from the front radio controls.
Hope this helps.
rayd113352@aol.com

Oct 15, 2008 | 2001 Ford Windstar

1 Answer

My third seat will not unfold so the kids can sit in it


Has it worked before, and now it does not. On the Windstar there are 2 levers, one on the left side of the seat in the front, and one on the back of the seats to the right you have to look at when the hatch is open.

Aug 07, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...