Question about 1995 Plymouth Voyager

1 Answer

95 plymouth voyger 3,8 engine vibrates under heavy accelaratioin replaced front cxels with reman then new .on help . one tire pressure to high brought pressure to spec 30 lbs . a little help. noticed toe out seems to high . havwnt been to a front end man yet . or could front end be set to low . I am a retired elect and ac specialist 78 years old . car runs to good to junk it just want it fixed . I live in a small towm rogers ville tn. the mechimacs do not get the problems that have in large towns. Robert horton 78 years old 35 years with chrysler line mech in atlanta . please help thank you

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

Jack up the car and check each front tire for movement up and down and side to side. up and down is a ball joint.. side to side is a tie rod end.
also remove each tire and roll it down the driveway and see how smooth it rolls. it could very well be a belt has slipped in the tire. replace it.


Posted on Jan 06, 2009

  • Roberta Smith
    Roberta Smith Jan 06, 2009

    i did forget to add... but very very important... make sure you have a secondary support for the vehicle (floor jack) for safety.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 plymouth voyger 3.3 fuel pressure spec

47-51 PSI engine at idle and fuel pressure goes up when you stab the throttle quickly.

Mar 30, 2017 | Plymouth Cars & Trucks

1 Answer

My 1993 Plymouth Acclaim is vibrating real bad after I reach a speed of 35mph. What could be causing this?

1. Alignment

2. Unbalanced tire(s)

3. Unevely worn tires

4. Unequal tire pressure

Dec 27, 2014 | 1993 Plymouth Acclaim

1 Answer

1999 plymouth voyger 2.4 motor 4 cylinder 3 speed wont go in reverse

your transmission is going.
park on a hill or in spots you can drive thru so you dont need reverse.
reman transmission for this year 3 speed is $800 installed, $525 bench job.

Mar 23, 2013 | Cars & Trucks

1 Answer

1999 Plymouth voyger hard shift in second

If the transaxle is over 3 or 4 years old or the
fluid is not changed every 2 years on that unit,
then it is failing

You could have a shop check the pressure control
pack on the outside of the case

Those transaxle have a very high failure rate
All carvans from the 1990's have

Mar 08, 2013 | Cars & Trucks

1 Answer

Vibration in front end since tire rotation

Check and make sure that the tires are well balanced and have the right air pressure in them

Feb 23, 2013 | 2007 Chevrolet Chevrolet HHR LS

3 Answers

I have a 1999 chevy silverado 1500 and I am getting heavy vibration at 40-65 mph it goes away at 70 mph and returns at 80 mph, I have had my tires balanced and checked. I have replaced the front wheel...

If the tires are round once checked on a balance machine to be true. Next check the driveshaft is a weight missing, dings or bent, u-joints loose?

Then check the rear ring

Aug 10, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Front shock replacement 1995 Plymouth Voyger

Those are the symptoms of worn shocks and struts. You should have them replaced by a mechanic. From choosing the low end not so high quality shocks/struts as the replacements, to the high quality OEM (Original Equipment Manufacturer) shocks/struts it should cost you around $250-$400. Let me please note that some times the shocks do not need replacing but that is at your discretion. Thanks for asking!
And don't forget! It's at your discretion leave a rating!. I always try my best at explaining my answer to your problem.

Jun 28, 2010 | 1995 Plymouth Voyager

2 Answers

Front end

could be a deformed tyre ,really need to drive it to see whats causing it

Dec 14, 2009 | 2006 Pontiac G6

1 Answer

We have a problem with excessive vibration at around 90 kph.We do a fair mix of on and off road work. We rebalanced the tires twice in a row and did a realignment and tightened up the steering box but the...

95% of the time a vibration at that speed, while cruising,(not braking or heavy acceleration) is from the tire/wheel assembly. What that means is ASSUMING the balance is done correctly...then..are the tires round?(generally no more than 60 thousands of an inch of lateral or radial runout) Are the wheels bent? I am ASSUMING the front end is tight. Finally, by weird chance you have a nylon belted tire from the old days it will shake until it warms up. That's an old brain cell! Oh, if you are getting "wheel hop", not vibration, then you have weak shocks/struts

Sep 19, 2009 | 2008 Mazda B Series Pickup

Not finding what you are looking for?
1995 Plymouth Voyager Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides