- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
SWITCH IGNITION ON, REPEATEDLY PRESS GAGE INFO BUTTON UNTIL THE MESSAGE TIRE PRESSURE IS DISPLAYED IN THE MULTIFUNCTION DISPLAY, PRESS AND HOLD RESET BUTTON UNTIL THE MESSAGE TIRE PRESSURE RESET IS IN THE DISPLAYED IN THE MULTIFUNCTION DISPLAY,RELEASE THE RESET BUTTON THE MESSAGE TIRE PRESSURE NORMAL WILL BE DISPLAYED IN THE MULTIFUNCTION DISPLAY, AFTER RESETTING TPMS THE VECHICLE REQUIRE UP TO 30 MINUTES OF STRAIGHT LINE SMOOTH ROAD DRIVING IN EACH OF THE 3 SPEED RANGES 15 - 40 MPH - 40 - 70 MPH - 70 - 90 MPH. MAKE SURE ALL 4 TIRES HAS THE RIGHT AIR PRESSURE BEFORE RESETTING TIRE PRESSURE LIGHT.OR LIGHT WILL NOT TURN OFF IF ONE TIRE IS LOW.
Have you tried resetting the light? On either the end of the dash on the drivers side or the end of the dash on the passenger side there is a panel that covers the fuse block. You'll need to have the door open to access it. Once you remove the cover you should see a button that says reset. Turn the key to the run position and press the button. The change oil message should flash, press the button again and the low tire message should flash, press and hold the button until the low tire light turns off. Sometime there will also be an audible series of beeps when it resets.
Your tire pressure monitor needs to be reset whenever you change or rotate your tires...
1. check and make sure that your tires are inflated to the correct pressure
2. turn the ignition switch to the ON position. If the low tire
pressure warning light comes on, push and hold the tire pressure
warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns
off and then release the switch.
3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.
4. initialization is *not* completed until driving at the vehicle speed
of 19 mph or over for more than one hour. the tire pressure monitoring
starts when initialization is completed.
Because of changing outside temps this happens, just hold reset button on left side of dash until it reads tire pressure 100% again, just make sure your pressure is right before you do it. this is the same for oil changes and the like.
Must have engine computer scanned to get codes and determine cause of check engine light. Low tire light probably needs reset. Open passenger door and remove panel on side of dash. Reset switch should be located in that compartment.
The tire reset button is for your tire pressure monitoring system. If you have the tires replaced or if you have a low tire the T.P.M.S. light may come on and the button resets the light after repairs are made.