Question about 1994 Jeep Grand Cherokee

1 Answer

Changed battery in 1994 jeep cherokee now engine won't start. Tried resetting alarm by unlocking drivers door and hatch door. Still not starting

Posted by on

  • 1 more comment 
  • texasflyer Jan 05, 2009

    no aftermarket alarm that I am aware of. It does have some sort of factory security system but I have no remotes. by unlocking the drivers door twice it clears the security light.

  • O Mclean May 11, 2010

    Does this vehicle have a push type valet switch??

  • O Mclean May 11, 2010

    Does vehicle have an after market ALarm

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Do you know how to check codes on your Jeep? Sometimes the crank position sensor goes out but the Jeep will still run until there is an interruption in power to the ECU. I had a 94 Cherokee do the exact same thing. Turn your key in the following pattern: off-on-off-on-off-on. Leave it on and look at the engine light - it will blink out 2 digit codes. If I remember right code 11 is for the crank sensor...

Posted on Jan 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My jeep Cherokee 1996 won't start how do I unhook the alarm to get it to start???


you have too unlock the alarm by turning one of the door locks try them all even the hatch as they are all different

Feb 09, 2013 | 1996 Jeep Grand Cherokee

1 Answer

I have a factory installed alarm on my 2003 jeep cherokee ,how do i disable alarm


Hello! The drivers side door lock/unlock switch is more than likely defective...Having said that, the alarm system on Jeeps are a constant problem...To disable the system requires removing the drivers door panel and cutting the Light Green/Orange wire at the switch...And installing a 465 Ohm resistor...Not something done without the necessary skills...
I would have the vehicle towed to a Jeep dealer and have them test the drivers door switch and disable the alarm....Guru...saailer

Feb 02, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Just brought a 95 jeep cherokee was left for like 8 month so dead battery jumped it and started 1st time with alarm goin and alarm wouldnt stop so had to drive it to mine like that soon as i got to mine...


Try locking and unlocking the drivers door using the key. Usually that will re-set the security system. Also try the rear hatch lock as sometimes that is used instead of driver door.

Jan 13, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Cant get 1996 jeep grand cherokee to start after alarm stopped


The alarm might have a relay to kill the ignition. Disconnect the negative or ground from the battery, wait five minutes then connect it again. This is to try and restart the alarm. Then lock and unlock the car to get the remote in sync. Try and operate your vehicle now and let me know.

May 06, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Alarm went off, car wont start. reset switch??


Pull the battery cables, hold them together for 3-5 minutes, this resets the cpu in the car. That should fix it.

Apr 24, 2009 | 1998 Jeep Grand Cherokee

5 Answers

Alarm activated,lights are flashing can't start vehicle


if alarm is activated, it could be shutting off the starter, hence no starting....you may have to have a locksmith or electronics place disable the alarm so you can at least drive the thing

Apr 16, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Security system


in the 1994 jeep the anti theft device can be over riden by using key lock/unluck back hatch open and close, then start engine as usual. each time u lock or disconnect battery u must do it again.

Apr 11, 2009 | 1994 Jeep Grand Cherokee

1 Answer

94 jeep won't start


have you tried manually unlocking the hatch to reset the security
system?? My 94 grand cherokee limited did not have a key pad to turn system on/off...i have reset it by turning the key in the rear hatch lock to the left twice...see if this works. - SmokeWrench

Aug 04, 2008 | 1994 Jeep Grand Cherokee

6 Answers

Jeep alarm will not turn off


The ignition security on/off is located at the trunk lock. unlock and lock rear gate and the alarm will turn off. My jeep sat in my drive for a month before a jeep tech told me this. It still triggers the security sometimes when I unlock the passenger door with the key and I go straight to the rear gate lock and it shuts off instantly.

Jun 27, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...