Question about 2008 Jeep Compass
Oil has been changed but can't get the oil change light to go off.
Turn key on til message appears,push gas pedal to floor 3 times (engine not running)
Posted on Feb 05, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: oil & filter change
Oil is one of the most important items inside your engine. It has a dual function...it keeps internal components from touching each other and wearing out, it also serves as a secondary cooling system.
Oil also carries away debris and moves it to the oil filter, holding smaller particles in suspension to prevent deposits.
Your vehicle is like a person that has a bad kidney and must go for dyalisis periodically. If not, bad stuff in their blood will kill them.
In all the years I've been in the auto industry, I have never seen anyone that had an engine failure of any kind from changing their oil too often. I have seen hundreds that did not change their oil with disasterous results.
Manufacturers have attempted to capitalize on the fact that the oil products we have today are far better than those we had years ago.What customer would not want a vehicle that was maintenence free? Oil filters used today are a bit better than older ones, but are also smaller. They do not have the holding capacity needed to operate properly over extended change intervals. When full, oil bypasses the filter and continues along through the engine.
These are the facts...Now here is what I think.
If you intend to keep your vehicle for any period of time, use the best oil available (I prefer synthetics) and change the oil filter at least every 4,000 miles. Then, you could follow mfg change schedule with some confidence. With a good synthetic, you could actually run all the way to 10,000miles with a "halftime" filter change. If using conventional oils, I would prefer to see oil changed every 4K or slightly less, along with filter. Don't forget...the dealer only needs your vehicle to last as long as the warranty, and actually needs it to fail after that so they can sell you a new one.
You would likely want it to last far longer!!! This applies to all fluids...coolant, brake fluid diff lube and trans oil...change more often and everything lasts longer!!!
Good luck with your car!!!
Posted on Apr 22, 2009
SOURCE: mechanic did not reset my
1. Turn the ignition switch to the ON position (Do not start the engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position
Posted on Jan 06, 2011
SOURCE: 2008 jeep grand cherokee reset
if it is the display on the console, select the change oil prompt, press and hold the select button for a few seconds. the display should read 'oil life reset 5000 mi'. if the display is above the rear veiw mirror near the map lights, select the oil life reset prompt, press and hold both the set, and select buttons at the same time. refer to owners manual for exact procedure if it still doesnt work
Posted on Feb 01, 2011
SOURCE: how do you reset change
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure."
Follow these instructions.
Posted on May 16, 2011
Tips for a great answer:
Oct 18, 2013 | 2008 Jeep Compass
May 16, 2011 | 2008 Jeep Compass
May 03, 2011 | 2008 Jeep Patriot
Feb 13, 2011 | 2009 Jeep Compass
Feb 01, 2011 | 2008 Jeep Cherokee Grand
Jan 05, 2011 | Jeep Wrangler Cars & Trucks
May 17, 2010 | 2008 Jeep Compass
Oct 21, 2009 | 2008 Dodge Avenger
Jul 27, 2008 | 2008 Jeep Patriot
214 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: