Question about Cars & Trucks

Open Question

WHERE IS THE AIRBAG SENSOR LOCATED ONA VAUXHALL VIVARO

WE NEED TO FIND THE LOCATION OF THE DEPLOYMENT SENSOR FOR THE AIRBAG ON A VAUXHALL VIVARO

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: vauxhall vivaro wont start cold

Sounds like a faulty cold start assistor. On top of the engine you will find an aluminium housing with four things that look like glow plugs screwed into it. These 'glow plugs' are only available complete with the housing fron Vauxhall. Approx £70 +
Airbag light is probably a fault with the seatbelt pretensioner.
Check the wiring under the seats for damage or perhaps the plugs have pulled apart.

Posted on Jan 28, 2009

jj127
  • 37 Answers

SOURCE: 2000 Chevrolet Malibu LS airbag problems

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

Posted on Jun 20, 2009

emissionwiz
  • 75817 Answers

SOURCE: center airbag sensor bad.

it is located in the front of the radiator on the radiator support if memory serves me correctly.

Posted on Oct 29, 2009

  • 1 Answer

SOURCE: Vauxhall Vivaro Van 53 plate. Wipers not Parking

hi i have the same problem...can you tell me if you have an answer yet???

Posted on Dec 22, 2009

drsinister69
  • 2317 Answers

SOURCE: where is the CTS AIRBAG SENSOR LOCATED?

On the front radiator support, usally a black box, it should have a plug on it.

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Where are the airbag sensors located in a 2003 honda accord?


The sensor is usually encased in a pnuematic piston located in the front bumper. You ran over a curb? You hit the bumper, it deployed.

Aug 13, 2015 | 2003 Honda Accord

1 Answer

P0340 vauxhall vivaro


not always cam sensor could be crank sensor if it cranks long and starts it can be crank sensor if it starts right away the cam sensor can cause a missfire as well if you have a pressure switch for oil level it to can cause no start check the oil level if its full it can cause a no start if this model is equipped

May 05, 2014 | Vauxhall Vectra Cars & Trucks

1 Answer

Outside temp sensor location vauxhall vivaro


It is located on a bracket in front of the radiator

Jun 28, 2012 | Cars & Trucks

2 Answers

I am trying to reset the srs light on my 1996 Mitsubishi colt. I have replaced the airbag and rotary switch(springs behind wheel) but cannot seem to locatate my airbag ecu. Where is the location of my...


If the airbag has been deployed, is is necessary to REPLACE the airbag (SRS) ECU. It is located below the center console. (See picture) It must be replaced because on your vehicle, it contains the crash sensors. If you do not replace it and hook-up new airbags and turn the key on, the new airbags will immediately deploy. There is no way to "reset" it.


dttech_92.gif

May 24, 2011 | 1996 Mitsubishi Mirage

1 Answer

Where's my fuel filter located in my vauxhall vivaro


opel vivaro ,its a belly tank and its mounted amidships ,about time they dropped the vauxhall and the holden names ,havent got a 1960s rust bucket cresta laying around in the garage have you ?? or a MkIV zodiac executive ,swop for a 1956 morris oxford ???

Feb 15, 2011 | Volkswagen Tiguan Cars & Trucks

1 Answer

I have a 2001 ford escape that was in a fender bender. minor visual damage but both airbags deployed. I bought new steering wheel and passanger airbag and hooked up. I was told i now need new sensors which...


this may sound crazy but this is what they say (manufactor) when ever airbags are deployed ,the following must be replaced,the deployed bags. the airbag module,crash sensors,clock spring, the belt buckles and seat belts should be inspected and checked.

Mar 08, 2010 | 2001 Ford F150 Styleside SuperCrew

2 Answers

Where are the airbag sensors on a 2002 Malibu? Daughter ran off road, hit ditch & did damage to right front from headlight down....both airbags deployed...is that normal?


Hi, the impact sensors for the air bags are usually located between the headlights more or less at the lowest point of the headlights. It is possible that the air bags will deploy as the impact sensors work with vibration. If the vibration is big enough to activate the sensor the air bags will deploy.

Nov 24, 2009 | 2002 Chevrolet Malibu

2 Answers

Vauxhall Vivaro Van 53 plate. Wipers not Parking


hi i have the same problem...can you tell me if you have an answer yet???

Sep 21, 2009 | 2003 AMC Encore

1 Answer

My airbags blew i need to replace them


You need to replace your "airbag diagnostic monitor", and the "airbag sensors" as well as the airbags.

Once your airbags have been deployed, the airbag sensors may be damaged and may cause deployment for no appearant reason. You must replace the airbag diagnostic monitor, because it's internal thermal fuse blows upon deployment, and will not deploy a new airbag.

If you purchase airbags, and related parts from a salvage yard, make sure the diagnostic monitor is the same model as the one in your vehicle (the model number is on top of the unit, the manufacturing date is listed last and is irrellevant), but ford does use the same unit in most vehicles of the same year.

To replace the system, disconnect your negative battery cable and wait 1 minute before doing anything. Your airbag system is designed to be able to deploy for 1 minute after a power failure, so do wait 1 minute before doing anything.

In a 1995, your airbag diagnostic monitor is located inside the vehicle, center console area, under the heater and blower control assembly. It is a silver box that has 2 wire clips connected to it, and is retained with a couple 10mm bolts. (Don't get it confused with the larger computer that is under the radio area, the monitor is behind the computer)

Your 2 sensors are located in the front of the grill area, and 1 is in the driver wheel well area. All are held in by a few bolts, and have a long wire clip attached.

The driver airbag is held in by 2 bolts that are easily accessed on the back of the steering wheel, then a couple wire clips inside the steering wheel.

The passenger airbag is held in by 4 bolts that are accessed, by removing the glove compartment, and a wire clip behind the airbag in the dash area.

Airbags blow with extreme power and can be as dangerous as helpful. If you intend on doing the work yourself, follow the instructions carefully.

Install everything in reverse, and DO NOT HOOK UP THE BATTERY UNTIL THE REPAIR IS FULLY COMPLETED!

I hope this helps you, and I wish you luck on your repair.

May 11, 2009 | 1995 Ford Thunderbird

1 Answer

Vauxhall vivaro wont start cold


Sounds like a faulty cold start assistor. On top of the engine you will find an aluminium housing with four things that look like glow plugs screwed into it. These 'glow plugs' are only available complete with the housing fron Vauxhall. Approx £70 +
Airbag light is probably a fault with the seatbelt pretensioner.
Check the wiring under the seats for damage or perhaps the plugs have pulled apart.

Oct 30, 2008 | 2002 Volkswagen Eurovan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

400 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...