Question about Honda Cars & Trucks

Open Question

My honda accord wont go when you step gas pedal it stop like choke

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 740 Answers

SOURCE: 1992 Honda Accord slowly accelerates

Sounds like a bad timing belt. timing belt may need to be replaced,or igniting timing may be off. here is a digram if you need help with timing .http://www.2carpros.com/car_repair_information/tec_info/1992/honda/accord/1992_honda_accord_timing_belt_diagram_marks.htm Good luck and thanks for using FIX YA.

Posted on Mar 04, 2009

breddi2
  • 126 Answers

SOURCE: need to replace radiator in 1997 honda accord se. what are the steps?

First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.

Posted on Apr 20, 2009

  • 850 Answers

SOURCE: how do i stop gas pedal from sticking on my honda

sounds like the accelerator cable has worn out [fraed]
replcae it!
Cheers Rob

Posted on Jul 20, 2009

  • 1 Answer

SOURCE: trunk/gas tank latch wont work (honda accord)

I have this problem now i got my trunk to lock by going in the trunk and removing the wire from the hook that was keeping it loose. Now i can lock my trunk but i am still looking for a way to get in my gas tank. Help me please if you can.

Posted on Dec 10, 2009

  • 1 Answer

SOURCE: 92 honda accord ex - No power on D4..

Describe what do you do if your D4 light is on a 92 honda accord ex and wont let you take off fast Problem

Posted on Jan 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Carburator choke wont set on 1984 honda hatchback when pumping the gas pedal. car wont stay running


Most carburated engines you don't pump the gas pedal, you slowly press it all the way to the floor one time and release it, then you attempt to start it. The problem that you are describing is an indication that the carburetor needs to be rebuilt. The choke plate has a latching mechanism that is connected to a heater coil, if there is excess wear on the parts or the heater is bad, it has to be replaced

Dec 10, 2016 | Honda Cars & Trucks

1 Answer

As soon as I start my 94 honda accord lx it's always revved up like I'm holding the gas pedal down a little what can this be


Its your choke revving up the engine untal it warms up. Once its warmed up it should not do it. If it does then the choke is stuck. Spray with some WD40.
It maybe more but simple stuff 1st. Mike

Mar 02, 2016 | Honda Cars & Trucks

1 Answer

85 HONDA ACCORD WONT STAY RUNNING UNLESS PUMPING GAS NOT EVEN FULL THROTLE


You have a single fuel injector in it right. Try right at the end of the gas pedal cable at the engine there is an electrical plug and a little device that goes around in a circle when the gas is mashed. That is the throttle position sensor. Try unplugging that and if there is no difference in the revving then the throttle position sensor is out. If that is not the problem, then plug your engine into a an onboard diagnostic reader. 85 is an obd1.

Feb 19, 2015 | 1985 Honda Accord

1 Answer

1988 5 speed Honda Accord


Ensure your spark plugs,wires (ignition coil and spark) and your filters (air and fuel) are within 2 years of installation It's erratic at 800 rpm as the engine is cold and they like the 2200 range for 3 minutes before they kick down on their own. Press the pedal twice before inserting your key. The owners manual states depending on the outside temperature, the engine will require more priming. Update if possible.

Oct 25, 2009 | 1988 Honda Accord 4 Door

1 Answer

I need to know the starting procedure for a 1988 honda accord carburator type enbgine


when cold you want to fully depress gas pedal twice and then with pedal released start car,this engages choke and fast idle

Oct 05, 2009 | 1988 Honda Accord 4 Door

2 Answers

92 honda accord ex - No power on D4..


D4 is slipping and not engaging. This means you need a transmission. you're losing a gear

Jul 24, 2009 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...