Question about Chevrolet Cars & Trucks

Open Question

Broken headlight adjuster on Chevy 2005 Tahoe

Looking for a part number so i can get one in the morning

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: how to adjust headlight of Honda 2005

open the hood by the lights u will see a hole wth a light symbl near it put a long screwdriver in and turn the click wheel thing that will raise/lower the whole headlight assembly. ADJUST THE LOW BEAMS BECAUSE THE WHOLE ASSEMBLY MOVES HIGHBEAMS ARE NOT AS IMPORTANT

Posted on Aug 07, 2008

Ad
lebones337
  • 152 Answers

SOURCE: 2005 chevy express van where is Headlight adjustments

here is a link to a repair guide for your vehice that will help you with the headlights along with any other thing you might need.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800b4a31

Posted on Feb 12, 2009

  • 540 Answers

SOURCE: 2005 tahoe no air blowing

as long as all the fuses are good.. its probably the blower resistor/module... located next to the blower motor under the pass. side of the dash..

Posted on Oct 13, 2009

  • 1986 Answers

SOURCE: How do you adjust the headlights in a 2005 Chevy

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

seanpwright
  • 2030 Answers

SOURCE: i need to adjust the headlight beam on my 04 chevy

If it passed inspection, technically the beams are aimed properly.....that is part of the required inspection.

Take it back to where it was inspected and have them correct it.

Inform them that they passed your vehicle without checking the headlights.....I'm sure they want to keep their inspection license :)

Posted on Nov 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chevy tahoe open hood when hood release broken


Take a pair of pliers, and pull the cable where handle hooked to it. Helps to have some one push down on hood while you pull cable.

Feb 25, 2016 | 2005 Chevrolet Chevrolet Tahoe Z71

1 Answer

How to adjust headlights


I installed eagle eyes aftermarket headlights on my 99 Chevy Tahoe I need to know how to adjust them. I know there is 2 adjustment nuts on top is that what I use to adjust them?

Jan 12, 2014 | 2004 Toyota Highlander

1 Answer

Chevy 2005 tahoe z71 blows cold air in back but hot air in front


Just got an answer from Chevy Dealer. When you replaced the battery it loses its memory as to where the door actuators were (the flaps that control the heat and A/C).

The fix:
Turn everything off and let the car sit overnight. The computer should reset itself during its learnings process.
In the morning turn on the ignition and let the car run for a few minutes before turning on the climate control.

If this doesn't work, plan on 1-1.5hours of labor for a technician to reset the actuators at the dealership.

Good luck.


Car Headlights.

Jun 01, 2012 | 2004 Chevrolet Tahoe

2 Answers

Where is adjustment screw for headlights on 2008 impalla


Vic, the adjuster is either a allen key, torx, or #2 philips type bolt found close to the bolt that is holding headlight in place on inner fender rail/flange. I believe on the Impala the only adjustment is up and down of the light beam. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to Adjust the Headlights in Chevy Impala eHow
How do you clean headlights on 2002 chevy impala
How To Change Install Adjust Headlights 2000 2005 Chevrolet Impala

Jan 11, 2012 | 2008 Chevrolet Impala

1 Answer

I have a 2005 chevrolet silverado my dashlights and headlights are strobing how do i fix them?


Are you having problems with headlights or interior lights flickering or dimming for no apparent reason? You are not alone! Many other consumers have reported experiencing the exact same problem. The problem is seen in many different GM makes and models including, but not limited to: Chevy Suburban, Tahoe, Silverado, Corvette, Camaro, Firebird and Malibu's and Pontiac Aztek's.
Why Are My Headlights Flickering?The headlight flickering or dimming may be caused by a intermittent low voltage output from engine vibrations. When this occurs, a voltage spike causes the voltage regulator to reset. During the reset, generator output drops to almost zero. This is a known issue with GM cars and the correction involves replacing the alternator. Would recommend seeing dealer for proper alternator application to resolve concerns. Probably has a superceded part number to indicate internal changes.

Sep 18, 2011 | 2005 Chevrolet Silverado

1 Answer

2005 headlight trouble


check the connection to the headlight its probably not on tight so when you beat on it it makes contact.

Feb 03, 2010 | 2005 Chevrolet Tahoe

1 Answer

My speedometer stopped working,what can the


usually a broken cable or a bad speed sensor depending on the car

Jan 10, 2010 | 2005 Chevrolet Tahoe

1 Answer

I need to adjust the headlight beam on my 04 chevy tahoe. there passed inspection but the beams arent' lighting the road properly.


If it passed inspection, technically the beams are aimed properly.....that is part of the required inspection.

Take it back to where it was inspected and have them correct it.

Inform them that they passed your vehicle without checking the headlights.....I'm sure they want to keep their inspection license :)

Nov 09, 2009 | 2004 Chevrolet Tahoe

1 Answer

1997 Tahoe Headlight Adjustment


the two large screws on top are to remove light totally.You need to look down the holes with a flash light to see the adjustments.

Oct 14, 2008 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...