Question about 1992 Buick Park Avenue

Open Question

92 buick Park ave starts then dies

My Buick starts then dies and has to be started a second time everytime I get in it? Is there anything I can do to stop this or is this going to potentially be a bigger problem later on?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1994 buick park ave

The turning over without the starts; my car does the same thing. I would just keep trying and eventually it would run. Well, I was told it could either be a bad ignition coil, or maybe an oxygen sensor going bad. A tune up might help too. Does this happen after rainy weather? It could be a crack that's allowing moisture in the ignition parts.

Not sure about the windows, sounds like an electrical problem. Check the fuses yet? It might be a bad solenoid switch in the doors. My passenger side door lock never opens with the auto unlock, but it does lock. I have to manually unlock it. I've just been too lazy to replace the part. The strange thing is that in the 2 years I've had it, it automatically opened ONE TIME out of the blue, but then the problem came back.

Posted on Jul 07, 2008

Ad
  • 6 Answers

SOURCE: 92 buick park ave security light on car wont start

Someone put the wrong key (resistor value) in the ignition lock, you will have to disconect the battery for 3 min. Make sure you have the right key. Very important! Make sure the climate control is off before disconecting/conecting the battery.

Posted on May 08, 2009

honeymokey
  • 3113 Answers

SOURCE: 1994 Buick Park Ave fuel pump or relay reset??

No switch. Take a big rubber hammer and strike bottom of tank while someone is cranking car. Sometimes this will make pump work until you shut it off to replace the pump.

Posted on Jun 13, 2009

carlsbiz
  • 1124 Answers

SOURCE: replace 2000 buick park ave serpentine belt

Firt - study & write down (draw) the belt path,,
and be sure about it..

Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..

Repeat to put new one on..

Should be pretty easy..

Posted on Jul 09, 2009

wracefans24
  • 1985 Answers

SOURCE: 98 buick park ave, hard to start, run's rough. po172 code

oxygen sensor in exhaust

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 98 buick park ave oil light blinks and stays on


The oil light is either a bad sensor or it's telling the truth that oil pressure is low. You can install a new sensor or hook up a mechanical gauge to find actual pressure. Cutting off can be caused by way too many things to list

Nov 27, 2017 | Cars & Trucks

1 Answer

Timing chain replacement 1997 buick park ave.


They are not prone to fail. I always recommend to replace only major when engine repair is needed.

Mar 27, 2013 | 1997 Buick Park Avenue

1 Answer

My 1991 buick will not start,and when i turn the ignition switch the car makes no sound with the exception of a click which comes from some box under the dashboard on the passenger side of the car,so show...


Try makking sure both battery terminals posts are clean and connected good and the battery is fully charged failing that tap the starter motor with a hammer while someone else tries to start it, here is a link to module locations on a 92 likely the same
https://www.justanswer.com/buick/813lr-i-m-working-1992-buick-park-ave-need-know.html

Dec 19, 2017 | 1991 Buick Park Avenue

1 Answer

92 Park Ave stalls, no codes..!


Sounds like the ignition module that sits under the coil packs ... did you ever get any codes out of it when the light was on ?

Jul 29, 2010 | 1992 Buick LeSabre

1 Answer

1991 buick park ave 3.8


reset the alarm/immobiliser.

Jul 11, 2010 | 1991 Buick Park Avenue

2 Answers

1992 buick lesabre dosnet wana turn over right away when started also dies when i will be driving but starts back up


Remove battery cables from battery and clean the connections on all three of them ,replace both bolts to fix.

Apr 27, 2010 | 1992 Buick LeSabre

2 Answers

Will a 2003 buick park avenue grille fit on a 1999 buick park avenue


THERE IS ALMOST FOUR YEAR DIFFERENCE.CHECK WITH AUTO PART BODY REPAIR SHOP.THEY CAN TELL YOU WHAT YEAR GRILLE WILL FIT CAR.

Oct 24, 2009 | 2004 Buick Park Avenue

1 Answer

92 buick park ave security light on car wont start


Someone put the wrong key (resistor value) in the ignition lock, you will have to disconect the battery for 3 min. Make sure you have the right key. Very important! Make sure the climate control is off before disconecting/conecting the battery.

Apr 18, 2009 | 1992 Buick Park Avenue

1 Answer

I can not find the neutral safety switch on a 2000 buick park ave


Sounds like passlock security failure.Park neatral swith located at top af transmission where shifter cable connects to trans,should be on drivers side.

Mar 03, 2009 | 2000 Buick Park Avenue

Not finding what you are looking for?
1992 Buick Park Avenue Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...