Question about Ford Cars & Trucks

Open Question

How do I remove the center dash of a 2008 ford escape to change the a/c switch

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: transmission problem

Here's a link you may want to read.
http://www.fixya.com/cars/t2320006-2008_ford_escape_transmission_cooler

Posted on Jul 10, 2009

  • 4 Answers

SOURCE: HOW TO INSTALL AHITCH ON A 2008 FORD ESCAPE

I have a 2007 Ford Escape Hybrid. The best hitch is the one available at your Ford dealer parts department. You cannot install a generic hitch because this is a unitized body/frame car. The Ford hitch bolts right onto existing bolts. It took me only about 2 hours to do the job. You have to cut a small square hole in the plastic bumper for the hitch to stick out.

Posted on Oct 13, 2009

  • 84 Answers

SOURCE: ABS & traction control just went out on 2008 Ford Escape.

Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Posted on Feb 03, 2010

Coleman37
  • 337 Answers

SOURCE: 2008 Ford Escape Horn Fuse keeps blowing after

I would trace the wire from the horn and see if it was inadvertently damaged when the alternator was installed. If you have a voltmeter, you can remove the horn fuse and check to see if there is continuity between the horn (non hot side) of the fuse and the car body. This would indicate a short in the wire running from the fuse box to the horn. You can also look around the alternator mounting area to see if any wires are being pinched. Hope this helps. Good luck!

Posted on Mar 10, 2010

  • 70 Answers

SOURCE: cruise control ford escape 2002. ford escape

If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

Posted on May 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have to push key real hard to start...Will not start at all now


2008 Ford Escape Have To Push Key In Ignition Very Hard ...

www.carcomplaints.com/Ford/Escape/2008/.../have_to_push_key_in_ig...
push key switch in hard to start 2nd time (3 reports) ... Our next step is to replace the lock housing assembly or the ignition lock cylinder. ... The ignition switch on my 2008 Ford Escape randomly turns over -- apparently when it feels like it.

Ford Escape ignition switch no start switch replac - YouTube

? 1:10
https://www.youtube.com/watch?v=bv8tDCf83Vc
Jan 28, 2014 - Uploaded by mosaitogo
Sometimes vehicle would not start when crank/start pos. ...having to push in on the key because the tip of rod is jumping out of switch . .... I currently have my ignition switch dangling down, and I just manually turn it with a screw driver .... Thanks I had this issue since last year with My Ford Escape 2008 but ...

22 Ford Vehicles No crank/ No Start Trick - YouTube




Dec 26, 2015 | 2008 Ford Escape

2 Answers

How do I remove the center console on a 2012 ford escape?


There is no codes under the console

They factory code comes with your owners
manual pkg

If you lost it or don't remember what you changed
it to,then you go to a dealer with your VIN # & proof
of ownership & pay them to get the code out of the veh

Sep 30, 2014 | 2012 Ford Escape

1 Answer

Ford Escape Heater Vent Control


suspect a control panel issue as this HVAC (heater, ventilation, Air conditioning ) system should be all electric... If you can pull the control panel out looking at the back of it will answer your question... are the cables or just wires..

Dec 28, 2013 | 2008 Ford Escape

1 Answer

Need bulb for 2008 ford escape center console


Need an owners manual for bulbs or have the lamp
out to read it's number

Apr 07, 2013 | 2008 Ford Escape

1 Answer

Dome lights on my 2008 Ford Escape


many cars have switches on the dome lights, to not come on to come on, or to come on with only dash lights brightness knob , check the setting of yours

Mar 11, 2013 | 2008 Ford Escape

2 Answers

My reset, info and trip button's on my 2008 Ford Escape wont work.


Disconnect the battery for 30 mint and see if this fix the problem , let me know .

Nov 15, 2011 | 2008 Ford Escape

1 Answer

2008 Ford Escape heater blower no longer runs in position 1. Works great in positions 2 thru 4.


It could be the blower resistor. While I'm not familiar with the 2008 Escape, most resistors are located near the blower motor under the dash on the passenger side. It'll have a plug with several wires, and usually 2 screws holding it in.

Aug 07, 2011 | 2008 Ford Escape

1 Answer

Change headlight assembly on 2008 ford escape


this video is very good
https://www.youtube.com/watch?v=ahRxmINq_Z8

Oct 17, 2009 | 2008 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...