Question about 2005 Ford Mustang

Open Question

How to turn off speed warning chime on a 05 mustang

At speed of 75 mph there is a warning that chimes and keeps on repeating intill you slow down below 70 mph

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Trans clunking when slowing down

Sounds like youi may have a few serious problems going on to have that kind of back lash occuring at higher speeds. I have experiance with low spped clunks on Bronkos and your type of vech being a car dealer. One you might try for low speed clunk on take off and braking at stop likts just completeing a stop? Pull the drive shaft and lubricate the splin - two check your leaf springs for weakness and wore bushings - take a look at your shocks - three u bolts holding springs to rear axle housing may be letting the axle housing actually dip or tweak or all those thing in combination - now you may have some serious slop in the pig - transfer case may be causing that clunk - as far as high spped clunk and activity you have a serous problem and you just might drop the transferr case have an accident fliping over..............Mike South Bend Indiana don't just keep driving and making problem worst...........

Posted on Sep 27, 2008

emissionwiz
  • 75814 Answers

SOURCE: warning chime disconnect

You will have to disconnect the warning chime module, it is on the driver side under the dash, follow the sound, it is about the size of a pack of smokes, it is usually black in colour.

Posted on Oct 29, 2008

motor1258
  • 6674 Answers

SOURCE: warning chime continues to chime as I drive

My guess is a faulty switch at door for turning off interior lights/door closed, which is giving chime that door is still open

Posted on Dec 21, 2008

  • 42 Answers

SOURCE: Unknown warning chime on 2000 Expedition

This is basically the door chime that stays on. I had the same problems in a couple Ford trucks. the only easy solution it to find where the chime speaker is on your expedition and disconnect it. It should be somewhere behind where your stereo is.

Posted on Jan 08, 2009

  • 1 Answer

SOURCE: door ajar light and chime come on while driving -

WD 40 or CRC WHITE LITHIUM GREASE SPRAY in each latch for the truck/car and open and close doors. Repeat and this should solve it.

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a way to fix the the turn signal chime and other various chimes on a 2009 Chevrolet Cobalt LS, there is no sound from them as well as front speakers?


The audible warnings alert the driver of a system concern or a critical vehicle condition. The radio generates the audible warnings through the speaker. The radio receives audible warning requests via the serial data circuit. If the radio receives multiple audible warning requests, the warning with the highest priority sounds first. The following lists the audible warning priority and the pulse rate:
?€¢
Fast rate chime (200 pulses per minute)


?€¢
Medium rate chime (150 pulses per minute)


?€¢
Slow rate chime (50 pulses per minute)


?€¢


Single chime

May 13, 2016 | 2009 Chevrolet Cobalt

1 Answer

How does one disconnect the warning buzzer?


Is it a buzzer or chime? There is a chime module under the dash that can be unplugged. Put your ear down low to find it and unplug it

May 10, 2015 | 2002 Ford Mustang

1 Answer

Speed alert cancel


what country , (GUESS) speed warning chime ?????
what country. each is different.
and you can cut the chime with wire cutters at any time.
i use ice pick like TV crime movies do, jab jab , chime dead.....for ever.
what speed, 120KMH?
best answer world wide, is:

"Once drove a 58 Buick that had a speed warning which was set at 90 mph and would start playing the tune "Nearer My God To Thee"

all posts say, ask your dealer.
no dealer, then i ask why buy a car with zero support and parts.
call em
email em
text em.
or drive in.

Dec 15, 2013 | 2007 Toyota Camry

1 Answer

1988 ford taurus wagon chimes everytime i go 45+ mph and the speed light flashes... what's wrong?


You probably have the speed reminder set to 45mph. It chimes & flashes to let you know you are speeding. It will tell you how to adjust it in your owners manual. If you don't like it set it high eg: 100mph. then it won't happen.

Jun 02, 2012 | 1988 Ford Taurus

1 Answer

Bmw x5 limit-mph light come


You need to reset the TPS to turn off the tire pressure light.

Limit MPH is just a setting. You can set it for 70mph for example and if you exceed that it will chime to remind you to slow down. If the system was set low, say 20mph, then it will chime evertime you drive the car. It has no effect on the car, its just annoying. Turn it of using the computer at the radio. there is a button there titled "Limit" press that and then adjust the limit to a higher speed. setting limit to "--" will turn it off.

Apr 16, 2012 | 2006 BMW X5 4.4i

1 Answer

'02 Rendevous beeping randomly, no lights or trouble indicatiors on. Beeps when parked, beeps while driving, no rhyme or reason apparant. sometimes goes 10 or 15 minutes without beeping, other times beeps...


The audible warnings alert the driver of a system concern or a critical vehicle condition. The radio generates the audible warnings through the left front speaker. The radio receives audible warning requests via the class 2 serial data line from the IPC or body control module (BCM). If the radio receives multiple audible warning requests, the warning with the highest priority sounds first. The following lists the audible warning priority and the pulse rate:
Fast rate chime--200 pulses per minute
Medium rate chime--150 pulses per minute
Slow rate chime--50 pulses per minute
Single chime

Is the sound heard different from typical Audible Warnings ?

Fasten Safety Belt Warning
The radio activates the fasten safety belt audible warning as requested by the IPC. The IPC sends a class 2 message to the radio indicating the chime frequency, slow rate and duration (5 pulses). The fasten safety belt warning sounds and the fasten safety belt indicator illuminates when the following occurs:
• The ignition switch transitions to ON.
• The inflatable restraint sensing and diagnostic module (SDM) detects that the driver's seat belt is not buckled, signal is low. The IPC receives a class 2 message from the SDM indicating the driver's seat belt status.
If the seat belt is buckled when the ignition is turned on, the chime does not sound. If the seat belt is buckled while the chime is sounding, the chime stops. If the seat belt is unbuckled after the initial transition to ON, the chime does not sound.
Headlamps On Warning
The radio activates the headlamps on warning as requested by the body control module (BCM). The BCM sends a class 2 message to the radio indicating the chime frequency, fast rate and duration, continuous. The headlamps on warning sounds when the following occurs:
• The ignition is OFF.
• The BCM determines that the driver's door is open, signal is low.
• The BCM determines that the headlamp switch is in the park or head position.
Key-In-Ignition Warning
The radio activates the key-in-ignition audible warning as requested by the BCM. The BCM sends a class 2 message to the radio indicating the chime frequency, medium rate and duration, continuous. The key-in-ignition warning sounds when the following occurs:
• The ignition switch is OFF.
• The body control module (BCM) determines that the driver's door is open, signal is low.
• The BCM determines that the key-in-ignition switch is closed, signal is low.
Turn Signal Reminder
The radio activates the turn signal warning as requested by the IPC. The IPC sends a class 2 message to the radio indicating the chime frequency, medium rate and duration, continuous. The turn signal warning sounds when the following occurs:
• The ignition switch is in the RUN position.
• The turn signal switch is in either turn position, sensing, within 1 second, an open to B+ transition in the turn signal control circuit, left or right turn.
• The vehicle has traveled a distance of 1.2 km (¾ mi) by counting pulses on the vehicle speed input circuit.
The IPC turns OFF the turn signal reminder when either the ignition switch is turned to the OFF position, or the turn signal switch returns to the OFF position, sensing, within 1 second, no transitions from open to B+ in either of the turn signal control circuits, left turn or right turn.
Additional Chimes
The following chimes will turn ON when an associated indicator/message turns ON in the IPC/DIC:
• ABS indicator
• AWD Disable indicator
• Battery/Charge indicator
• Brake indicator
• Change Engine Oil indicator
• Door Ajar indicator
• Hot Coolant Temp indicator
• Low Brake Fluid indicator
• Low Fuel indicator
• Low Oil Level indicator
• Low Oil Pressure indicator
• Low Tire Pressure indicator/reset
• Low Washer Fluid indicator
• MIL (Service Engine Soon) indicator
• Oil Life Reset
• Park Lamp Out indicator
• Rear Hatch Ajar indicator
• Service Traction System indicator
• Service Vehicle Soon indicator
• TRAC OFF indicator
For a description of an indicator refer to Indicator/Warning Message Description and Operation .
For diagnosis of an indicator refer to Symptoms - Instrument Panel, Gages and Console .

Did the Mechanic check for DTC'S - diagnostic trouble codes in the BCM or insturment cluster ? Did you try a Buick dealer ?

Jul 09, 2017 | 2002 Buick Rendezvous

2 Answers

How do you stop / turn off an 89 Mustang chime / buzzer?


If You Are Talking About The Door Chime There Are Two Ways To Do It One Is To Simply Unplug the Chime Two Is To Remove The Steering Columm cover and Unplug the black wire that is going to the side of the key switch I would Recommend This Method Because Unpluging The Chime Its Self Will Disable the Headlight on Switch off Warning As Well Removing The wire From Switch on column will disable key in switch door open only

Aug 17, 2009 | 1989 Ford Mustang

1 Answer

03 Chevy 2500HD Service Brake System Warning


When you replaced the ABS sensor on the hub, did you clean and re-gap the sensor to the speed ring on the hub. There was a recall on the ABS Malfunction on your truck. The tire size don't make a difference to your ABS as long as all four tires are the size, There was a issue bulletin with your Tahoe on the ABS activating under 8 km/h. Good luck and hope this helps, if not clean out the sensor with brake parts cleaner and check the wire harness and ABS sensor bracket. Re gap the sensor to the speed ring hub. Here is the bulletin. Anti lock Brake (ABS) Activation at Low Speeds (Clean Wheel Speed Sensor Mounting Surface) #03-05-25-007C - (05/16/2006) 2001-2006 Chevrolet Suburban, Tahoe, Silverado

Jun 25, 2009 | 2000 Chevrolet Silverado

1 Answer

Warning bell won't stop sounding


Section 13-09: Gauges, Warning Devices — Chime System 1996 Windstar Workshop Manual
DESCRIPTION AND OPERATION Warning Chime Systems Three distinct sounds are used to indicate the area of concern. Seat belt warning generates 1 chime per second
key-in-ignition generates 2 chimes per second
headlight on generates 4 chimes per second.
Key-In-Ignition Warning The key-in-ignition warning will sound when the driver's front door (20125) is opened with the key in the ignition switch. It will continue to sound until the key is removed, the front door is closed, the ignition switch is turned to START or the vehicle speed is over 24 kmh (15 mph).

Safety Belt Warning When the ignition switch is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled.
  • The safety belt warning indicator lamp (10C859) will activate for 60 seconds or until the driver's safety belt is fastened. Both the chime and lamp activate at the same time.
Anytime the ignition switch is released from START and returns to RUN while the safety belt lamp or chime is activated, the safety belt warning lamp or chime will remain activated until either the timing sequence has been executed, or the safety belt is buckled.

Headlamp Switch On Warning The chime will be activated if the headlamps or parking lamps are ON, the key is not in the ignition and the driver's door is opened. The chime will sound at a rate of four per second.

Apr 23, 2009 | 1996 Ford Windstar

1 Answer

Warning chime continues to chime as I drive


My guess is a faulty switch at door for turning off interior lights/door closed, which is giving chime that door is still open

Dec 10, 2008 | 1997 Ford Mustang Cobra

Not finding what you are looking for?
2005 Ford Mustang Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...