Question about 2005 Peugeot 307 1.6
Posted by Anonymous on
How To Test For A Car Battery Power Drain
Hi , A fully charged battery is 12.6. The link below is a short you tube video on how to find out if a car battery has a power drain, The video starts with the guy loosening the negative lead to the battery then turns the multimeter on and sets it to 20 DC, plug bottom of lead to current mode and places 1 multimeter lead on top of the terminal inside the negative lead and the other multimeter lead on the negative lead and wiggle the negative lead off the battery, The current being drawn from your battery should be less than (5.0) 50 mille volts..... The reason he takes the negative lead off after connecting the multimeter this is to save any codes from the car as technically the battery isn't disconnected..... CHEERS..
How to Find Car Battery Drain
Diagnosing car battery that drains overnight
Posted on May 11, 2016
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: peugeot 307 heater blower fault
i just had the same fault, but being in the trade it is normally only 1 of 2 problems.
the heater resitor packing up or the wiring loom.
both can be bought through peugeot.
try the heater resistor first (£40). to find it undo 7 star screws to remove glove box then look in behind centre conlsole near back of radio diconnect the black plug with a red and black cable. twist back of fan motor clockwise and remove fan(it's a bit of a tight squeeze to remove),then put your hand inside the hole you just made till you feel the flat resistor turn this anti-clockwise and disconnect green plug then reassemble as removed,
if this does not fix it then it is the loom, to remove this it is best to follow the wires from the back of fan motor up to where i think if i remember lead to 2 other plugs 1 green and 1 black on the way to another green plug up behind the drivers foot well, then thread the new loom back the same way.
on the 405 i think the resistor is in behind the fan motor accessed throgh the driver side footwell again you need to first take out the fan motor normally twisted anti-clockwise. it is un common for 405 to burn out heat resistors it is normally down to a wire fault.
hope this helps
Posted on Jan 18, 2009
if it says the diesel filter, then that is what it means,a fuel filter.normal service requirement on any vehicle and can be done for small dollars at any garage
Posted on Dec 04, 2009
SOURCE: peugeot 307 1.6
peugeot and citreon cars do bite high generaly, it is hydaulic there is no adjustment. but it also depends on how high it is ?? does it slip if you slightly rest your foot on whilst driving?? they do have a problem with the bearings going through the cover as it is the same bearing as a HDI . but you woud notice this as a different problem. ie noise or vibration on pedal. call me for more info .. paul @ the clutch centre..01527 64440 07790438337
Posted on Mar 19, 2010
Tips for a great answer:
Sep 05, 2017 | Cars & Trucks
May 11, 2016 | 2006 Peugeot 307 1.6
Feb 18, 2015 | 2002 Peugeot 307
Jan 15, 2015 | Peugeot Cars & Trucks
Nov 04, 2013 | 2005 Peugeot 307 1.6
Dec 07, 2012 | 2002 Peugeot 307
Apr 04, 2012 | 2002 Peugeot 307
Jan 17, 2010 | 2005 Peugeot 405
Jun 28, 2014 | 2005 Peugeot 307 1.6
1,766 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: