Question about Isuzu Cars & Trucks

Open Question

2005 Isuzu Dmax starter relay - Isuzu Cars & Trucks

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 148 Answers

SOURCE: I need a part number for an injector pump for an

Not really familiar with this vehicle, but being a 2004, probably does't have an injection pump.Probably a common rail, with a hight pressure oil pump. Best to have it checked by qualified diesel tech as replacing parts can be time consuming and expensive.

Posted on Feb 01, 2010

Ad
  • 6982 Answers

SOURCE: my isuzu dmax oil pan

In order for that dent to have any real effect upon oil delivery, the dent would need to be perfectly flat up against the oil pump pickup. Chances are it isn't. The pickup in most pans is located a bit above the pan bottom to lessen the chance of ingesting any contaminants (sand, grit, hard carbon etc). With the clearance diminished, chances of that are greater.
While only oil pressure is measured, volume is also important. With the pan that close to the pickup, pressure probably won't be a problem but you may loose some volume (impossible to tell how much).
When I put together a fresh engine, I like to see pressure of about 40psi or better. As an engine wears, engineers claim that anything above 15psi is OK...I use a higher number of 25psi (at idle) as a minimum "safe" limit. Anything below that, you know you have a problem and it's wise to find it early and fix it. (Pumps rarely fail...most low pressure problems can be traced to engine bearing wear, resulting in bleed off past the bearings)
As for your pan: If the pan is bent, and you have it off the engine, why not hammer the bend out a little? or, better yet, get another pan from a scrapyard and replace it entirely?
If you have not removed it, there's no real way of measuring and what you are seeing may not be the whole story...pickup clearance may be greater elsewhere. In that case, just continue doing regular service and save pan replacement for a day when you have time to do it.

Posted on Mar 30, 2011

headstrong56
  • 493 Answers

SOURCE: isuzu DMAX sudden power loss

could be fuel filter clog.air filter or MAP sensor or an intermittent speed sensor on the transmission

Posted on Jul 13, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2013 Isuzu D-max valve clearances?


what car , Dmax
what engine? they have many engine choices world wide...
what country,

Jul 28, 2016 | Isuzu Cars & Trucks

1 Answer

Hi 2005 Isuzu Rodeo Dmax Diesel 110k miles Ireland . Cold start after Glowplug warm up, at key turn does not crank engine at all, just silence. 10 min.'s wait. today no prob with engine crank.


does car have and immobilizer on it (we dont this car in usa)thanks of saying country... VG!
intermittent no cranks!
check battery lugs for the green corrosion.?
to diagnose, no cranks, like this takes using a voltmeter. (at point of failure)
to find out witch path fails.
loss of battery power,(batteries are notorious for this) 12.6vdc rested ,
next time it don't crank, jumper cable crank it over, off a donor car.(like tow trucks do)
or swap in a known good battery form other car.
does it crank now? if yes, suspect a bad battery.

no? then we hot wire the starter solenoid,
no crank now? then bad starter.(intermittent)
or if it cranks now, yes, then a bad key line/
i'd scan the PCM to see if it's the immobilizer, blockage,(bad key errors,etc)
or other issues.
my guess it's an automatic transmission
crank it , in neutral? the operators guide shows how to do that.
if it always starts in neutral, then the Park switch is bad, in trans.(intermittent as all do)
eventually.
or intermittent starter relay.
(diy magic)
rap the relay with end of screw driver, crank now?
wiggle shifter, in park start now?>
crank in neutral, start now?
rap side of starter, with dead blow hammer, gently
like cracking a walnut not breaking rocks.
did those allow cranking?
wiggle those 2 huge battery cables. crank now>?
end magic.

Feb 12, 2016 | Isuzu Cars & Trucks

1 Answer

Isuzu dmax has got a problem it starts but produces a thick white smoke and cant accelerate hence no power!kindly help!


check the oil dip stick to see if water has got in to the oil, if it has the oil will be a light brown ish colour, and if so then I am afraid you have blown the head gasket (Not a cheap fix sorry)

Sep 30, 2014 | Cars & Trucks

1 Answer

Want to know where to conect blue and black wire on isuzu dmax gearboks


If there only two wires then check the blue one for power and if so then the wires will probably go on the reversing switch

Dec 29, 2013 | Isuzu Rodeo Cars & Trucks

1 Answer

Where can i get rid of a brand new Isuzu DMax tub


I am looking for a Isuzu dmax tub ,, contact number 0419264083

Mar 14, 2013 | Isuzu Pickup Cars & Trucks

1 Answer

Isuzu DMAX sudden power loss


could be fuel filter clog.air filter or MAP sensor or an intermittent speed sensor on the transmission

Jul 13, 2012 | Isuzu Cars & Trucks

1 Answer

First this isuzu dmax just stop suddenly,i clean the fuel filter then clean the cencor in the tank,then the cencor connceted to the pump then it manage to start and idle properly but the engine check


to whom it may concern. my dmax model 2006 3000 cc lately having problem like engine suddenly stop especially when it slow,fuel filter already new fuel line been check but the problem still there.anyone been encountered this problem before what is the problem?

Jul 01, 2012 | Isuzu i-280 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...