Question about Cars & Trucks

1 Answer

I changed the differential cover gasket on my 95 GMC safari. Now the van is making a wierd noise like the big lifted trucks that have big wheels. Need to know what's wrong

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

Did you add fluid

Posted on Nov 09, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: gmc safari van

it should be the switch on the tranny that turns on the reverse lights.

Posted on Oct 27, 2008

  • 7 Answers

SOURCE: GMC Safari Van - Change spark plugs

i went under for driver side then i took off passenger side wheel you also have to remove two bolts that are holding dipstick tube in place it is easy to get them from the wheel well on passenger

Posted on Nov 17, 2008

  • 740 Answers

SOURCE: 1999 GMC SAFARI VAN REAR END HUMMING

This rear end needs to be replace or re-built


































This rear end needs to be replaced or re-built. The gears and or bearings are worn/shot. May be able to get a complete rear end from a Junk yard for much less, one in good condition. Good Luck






Posted on Dec 10, 2008

  • 1 Answer

SOURCE: I need to find and change the fuel pump relay on my 1993 GMC Safari. Any help?

I don't have the whole solution, but I do know that my fuel pump is in side the gas tank on my GMC Safari. Hope that helps!

Posted on May 08, 2009

  • 26 Answers

SOURCE: Rear Wheel Seal & Bearing on 1999 GMC Safari Van

Yes you do have to pull the axle and make sure you put everything back in the same place you removed it from. The ring and pinion shouldn't have to be bothered. You will have to remove the rear end cover to remove the axle. Its very easy to do. There is a pin inside the rear end that has to be removed to pull the axle. Pay attention to how you take it out and put it back the same way. It sounds as if you can do this with no problem.

Posted on Apr 11, 2010

Testimonial: "Thank You for your help, by answering my question. I'm on a fixed income and I can't pay to have this done and so I'm off to the Auto Parts Store. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I change rear wheel bearings on my 1992 GMC Safari van


Put the rear up on jack stands and remove the wheels and brake drums. Then unbolt the rear differential cover and drain the gear oil. Then, you remove the pinion securing bolt. DO NOT ROTATE THE WHEELS AS THIS CAN CAUSE THE PINION GEARS TO FALL OUT. Push the rear axle shaft inward toward the vehicle and remove the "C" clip that secures the axle to the pinion gears. Then pull the axle shaft outward and out of the axle housing. Inspect the axle shaft for scuffing and excessive wear on the place where the wheel bearings rest. If there is excessive wear, you can use a "repair bearing", which is modified to install so it runs on an unworn part of the axle shaft. Otherwise a regular replacement bearing is fine. You need a slide hammer removal tool to extract the old bearing from the axle housing, and a bearing install tool to insert the new one without damage. Once the new bearing is in, reinsert the axle shaft, secure with the "C" clip, and pull outward to latch the "C" clip into its recess. Install the pinion bolt. Reinstall the differential cover with appropriate gasket or sealer. Fill differential with approved gear oil in the recommended amount. Ensure that if the rear is a positraction rear end there may be an additive required to the gear oil for proper operation.

Sep 24, 2015 | GMC Cars & Trucks

1 Answer

Were is blower motor in 95 gmc safari


Under the hood, passenger side. If you go to YouTube and type: astro van / safari 95 blower motor replace, it'll actually show a guy doing the job.
Good luck!

Dec 28, 2012 | 1995 GMC Safari

1 Answer

I'm a getting a 95 astro van from a relative he says the rear differential is done it makes a thumping noise when driving what could it be and would it be better to get another rear end or just replace the...


Depends on what parts are needed. They range from $20.00 to several hundred. First find out where the noise is. Start at the drive shaft, check the universal joints.Check wheel bearings/ seals for leaks. Take off the rear cover and look at the differential. check for missing teeth. missing clips , metal on the bottom. Let me know I can help.
Randy

Apr 25, 2011 | Chevrolet Astro Cars & Trucks

1 Answer

Rear Wheel Seal & Bearing on 1999 GMC Safari Van


Yes you do have to pull the axle and make sure you put everything back in the same place you removed it from. The ring and pinion shouldn't have to be bothered. You will have to remove the rear end cover to remove the axle. Its very easy to do. There is a pin inside the rear end that has to be removed to pull the axle. Pay attention to how you take it out and put it back the same way. It sounds as if you can do this with no problem.

Apr 11, 2010 | 2000 GMC Safari

1 Answer

How to change the sparks plugs of my GMC SAFARI VAN 1998, 6 CYLINDER?


the best way is to do it through the wheel wells ,remove the tires and you should be able do see all the plugs,youmight have to lift up on the rubber dirt shield.

Feb 01, 2010 | 1998 GMC Safari

1 Answer

I have a vibration noise at highway speeds and its noy felt in the sterring wheel.its a 2000 gmc safari awd van.


you need to have the front end inspected those vans are notorious for idler arms

Dec 09, 2009 | 2000 GMC Safari

2 Answers

95 GMC Safari AWD frontend noise


Sounds like the brake pads is still slightly making contact with the rotor. Replace pads and / or rotor.

Could be that the pads are wore out and are just scraping the rotor. Definately replace pads AND rotor.

Could be that the pads have broken their clips and are flopping around.

Could be a rock stuck in the overall brake assembly.

Feb 09, 2009 | 1995 GMC Safari

1 Answer

1999 GMC SAFARI VAN REAR END HUMMING


This rear end needs to be replace or re-built


































This rear end needs to be replaced or re-built. The gears and or bearings are worn/shot. May be able to get a complete rear end from a Junk yard for much less, one in good condition. Good Luck






Dec 09, 2008 | 1999 GMC Safari

1 Answer

GMC Safari Van - Change spark plugs


i went under for driver side then i took off passenger side wheel you also have to remove two bolts that are holding dipstick tube in place it is easy to get them from the wheel well on passenger

Oct 22, 2008 | 2000 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...