Question about 2002 Volvo C70

1 Answer

I am sure there is a simple way to lock and unlock - I have pushed every switch on the drivers side door. We did have them work from the back for a while but not now. They go up and down fine from the front.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Sounds a switch or the switch can be getting wet

Posted on Nov 09, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: 1996 Volvo 960, Driver's motorized seat stuck

maybe you got pennies money stuck in the track if not you got 1 motor for that the motor goes in a assembly in there you have 2 cable a left and a right lock under the seat you probably got the right cale disconnect sometime there stuff that push under the seat and push that cable off if its that just push the cable back in let me know and please if you can take the time to rate this thank you pierre
p.s when you try to put the cable back in dont force to mush
PIERRE

Posted on Jun 29, 2008

SOURCE: how to remove front door

Pop the grab handle cover off, two different styles.

1. With a slot under the grab handle, take a small screw driver off and gently push up, it should just pop out.

2. Simple cover that can be separated with a bone tool or similar so you don't chip the cover piece.

Behind that you will find two Torx 25 screws, Take those out.

Around the edge of the panel should be around 8 plastic rivet type of thing.

Again...two different styles.

1. With center pins that blend in perfectly with the rivet. Should be about 3/32nds diameter. Push the center in and the rivet deals should pop out. Be sure not to lose the center piece...easy to lose.

2. Same deal but with a larger center pin.

Take the plastic triangle piece near the upper right hand area as facing the panel.

Pull bottom away from door and up to release from top section of door.

Careful removing the cable for the door lock release, and remove the connectors from the tweeter and driver's door module.

Posted on Aug 14, 2008

zappanut
  • 959 Answers

SOURCE: Passenger side window won't go back up on 2002 volvo S40

try activating it from the passenger side door switch. (working with the idea it is a switch problem).
then try listening real close when you try to roll it up... if you hear the motor running , it is the tape that is the regulator.

Posted on Nov 22, 2008

  • 42 Answers

SOURCE: driver's window won't go up

Your contacts in the drivers window switch are failing. Short answer is that you need a new master window switch assembly

Posted on May 13, 2009

VOLVOCHICAGO
  • 33 Answers

SOURCE: 1999 Volvo V70 - The tailgate door will not unlock

you will need new t gate lock assembly parts inside are worn out

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I tried to program a new fob for a 1999 Altima. And nothing worked





1.   Close and lock all doors with the driver’s side power lock/unlock switch.

2.   Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.

3.   Insert key into the ignition cylinder and turn to the ACC position.

4.   Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.

5.   If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).

6.   Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.




Make sure you have the right fob for your car.

Nov 15, 2016 | 1999 Nissan Altima

1 Answer

Buick 2002 LaSabre Custom all windows do not go up and down, door lock/unlock switch drivers side does not work(passenger & rear doors lock/unlock door switches work, trunk release button does n


coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Oct 24, 2012 | 2002 Buick LeSabre

2 Answers

My door locks won't work. They aren't working with the remote or the switch in the car. I can manually push them down, but even using the key in the door only unlocks the driver side.


In drivers side is damaged the driving motor for central doors locking. When is not works other doors also do not work! Try to unlock the car from the passenger side and you will see that the door is open all outside the driver's door! So you know that there is a problem!

Jun 30, 2010 | 2005 Dodge Caravan

3 Answers

Driver side door doesn't lock or unlock with the remote. The rest of the doors work fine.


Does the Driver side door lock and unlock from the lock switch inside? If not then you have a bad motor or bad connection to the lock/unlock motor inside the door.

Jan 08, 2010 | 2004 Toyota Camry

3 Answers

Driver side lock


the solenoid may be weak, or it can be lubed. you will need to remove the door panel and see how it works, and try to lube it, or see if there is any binding.

Oct 12, 2009 | 1999 Honda Civic

2 Answers

2001 Honda Civic power door locks no longer work


I have the same problem. The battery in the remote was replaced, still cannot operate lock. I can operate the balance of the door locks from the inside, except for the drivers side. I manual have to push or pull the door lock.

Apr 23, 2009 | 2004 Honda Civic

1 Answer

Doors/Locks


Pull drivers rear door panel off
1. Remove door lock solenoid and plug it into another door to see if it works
2. If you can reach inside the door to the final mechanism that everything pushes on, push it yourself to see if it works
3. Also look on side of door for possible child saftey lock switch

Dec 23, 2008 | 1997 Chevrolet Suburban

Not finding what you are looking for?
2002 Volvo C70 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...