Question about 2005 Mazda RX-8

Open Question

How do you take a 2004 mazda rx8 ac/heat control unit out?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 32 Answers

SOURCE: how to change spark plugs 2004 mazda rx8

Jack the drivers side up and secure on jack stands. Remove the drivers side front wheel. You can then reach through the fender well to remove and reinstall the spark plugs.

Posted on Jun 20, 2009

techbuster
  • 5081 Answers

SOURCE: how do i change both front and rear brake pads on

CHANGING FRONT BRAKE PADS
Jack up the car. Take off your tire. Find the bolt on the back of the caliper and take it off. This should release the caliper, pull the caliper off the disc. Now you should be able to take the pad out. Replace the pad. You'll need a special tool to reset the caliper. As the brakes wear down, the caliper gets tighter so the brakes still work. I'm not sure exactly what its called, but you can borrow one from auto zone. Follow the instructions that come with it to reset the caliper. Slide the caliper back over the disc. If it doesn't go on, you need to reset the caliper more. Put the relese bolt back in. Put your tire back on.Drive slowly and test the brakes.
CHANGING THE REAR BRAKE PADS
The rear brakes on the rx8 are a bit different than most setups...be careful! The only way to move the piston back into the caliper is by way of a special allen head bolt that is directly behind the piston, on the back side of the caliper, installed under a 14mm bolt.
You have to remove this bolt to gain access to the allen head. As you loosen the allen head bolt(counter-clockwise), the piston will move back into the caliper.
Installation is pretty typical, again, the allen head bolt being the unusual part. The manual says to tighten this bolt until the pads contact the rotor, then loosen the bolt 1/3rd of a turn, then reinstall the 14mm bolt.

Posted on Sep 04, 2009

  • 4 Answers

SOURCE: 2004 mazda rx8 power steering

The Mazda RX8 has electric power steering there is no fluid. You may have a problem with you electronic power steering control moduel, or the power steering pump

Posted on Dec 04, 2009

  • 2 Answers

SOURCE: can you convert a mazda rx8 to lpg

i checked up on this and the answer is no due to the way the rotary engine works

Posted on Mar 07, 2010

  • 1 Answer

SOURCE: have there been recalls for mazda rx8 2004

Do you mean the oil coolers?There was a recall for the oil cooler pipes which suffer very badly from corrosion

Posted on Nov 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda rx8 2004


Hey all, found a do-it-yourself guide to fix this problem. I plan on doing it, then sending Mazda a bill for the labor at standard shop rates. :-)
http://www.rx8club.com/do-yourself-forum-73/diy-no-heat-repair-heater-control-158200/

Sep 01, 2014 | 2004 Mazda RX-8

1 Answer

How do i unlock the security system for my 2004 mazda rx8


hola tengo un problema con mi mazda rx8 la luz de sistema de segurida esta predida y no puedo encender el carro que puedo hacer??

Jul 21, 2012 | 2004 Mazda RX-8

1 Answer

My heater in my 2004 rx8 only blows cold air even when I have it turned to heat. Can I fix this myself?


We're having the same issue with our 2004 RX8. Our's is not consistent, it only happens occasionally. Sometimes it works and sometimes it won't.

Nov 17, 2010 | 2004 Mazda RX-8

2 Answers

I have a 2004 mazda rx8 i just got it and the ac blows hot air like i have the heater on do you think it just needs recharged


It is more than likely a wire that is loose on the back of your ac/heater control. You need to have it soldered or you can do it yourself by taking the dash apart and pulling the heater control out and soldering it yourself...save yourself some money. :)

May 14, 2010 | 2004 Mazda RX-8

4 Answers

How do I fix the power steering n my mazda rx8 04?


My RX8 had the same problem. First, change your battery cable ends. On the Positive cable there is a white wire that powers the power steering. It probably has a bad connection at the battery post. I cut the end off my rx8 and just put a regular battery cable end on it and my problem was solved.

Jan 06, 2010 | 2004 Mazda RX-8

3 Answers

2004 Mazda RX8 Heater problem


There is a well known problem that is a manufacturer's defect with the soldered connection on the circuit board behind the temperature knob. There is a fix to re-solder the connections but the dealer will gladly take $450 to replace it with the same bad board that will last you a while. Look for the link to show you how to fix it yourself.

Dec 11, 2009 | 2004 Mazda RX-8

1 Answer

Can not get any heat to come into the interior of a 2004 mazda rx8


i have no heat comeing out at all it will come out when its ready to

Oct 12, 2009 | 2004 Mazda RX-8

2 Answers

Program keyless entry for mazda rx8


its a dealership and computer job by them, you cant do it yourself

Jul 10, 2009 | 2004 Mazda RX-8

1 Answer

Heat will not switch on


sound like a stuck blend door motor, not switching back and forth from hot to cold. the most likley cause is a bad heater control panel not commanding the motor to move as requested.

Feb 18, 2009 | 2004 Mazda RX-8

3 Answers

2004 mazda rx8 power steering


The Mazda RX8 has electric power steering there is no fluid. You may have a problem with you electronic power steering control moduel, or the power steering pump

Jan 17, 2009 | 2004 Mazda RX-8

Not finding what you are looking for?
2005 Mazda RX-8 Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...