Question about 1992 Acura Vigor

1 Answer

How can i get to the fuel pump on a 92 acura vigor?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 496 Answers

  • REMOVAL & INSTALLATION
  • Print
    The fuel pump on all models except the 1986-90 Integra, is located in the fuel tank. On the 1986-90 Integra the fuel pump is located under the rear of the vehicle, near the drivers side of the fuel tank.


    PRESSURE TESTING

    See Figure 1
    On all models, the fuel pump should run for about 2 seconds when the ignition is first turned ON . By removing the filler cap and listening at the filler, it should be possible to hear the pump run each time the ignition is switched ON . It will then stop again until the starter is activated.


    how can i get to the fuel pump on a 92 a - 0900c1528004984f.jpg enlarge_icon.gif

    Fig. Fig. 1: Checking the fuel system pressure

    1. Disconnect the negative battery cable and remove the fuel filler cap.
    2. Relieve the fuel system pressure.
    3. Remove the service bolt and attach a fuel pressure gauge to the top of the fuel filter.
    4. Start the engine and measure the fuel pressure with the engine idling and vacuum hose to the pressure regulator disconnected;



    1986-1989 Integra-35-41 psi. (240-279 kPa) 1990-93 Integra-37-44 psi. (255-304 kPa) 1989-90 Legend-36-41 psi. (250-279 kPa) 1991-93 Legend-38-46 psi. (265-314 kPa) Vigor-43-50 psi. (300-350 kPa)
    1. Check to see that the pressure decreases when the vacuum hose is connected.
    2. If the pressure is higher than specifications, check for a pinched or clogged fuel return hose or faulty pressure regulator.
    3. If the pressure is lower than specifications, check for a clogged filter, defective pressure regulator or leakage in the fuel line.
    4. After inspection, remove the pressure gauge and install the service bolt with a new washer.


    REMOVAL & INSTALLATION

    1986-1989 Integra

    1. Disconnect the negative battery cable.
    2. Relieve the fuel system pressure.
    3. Raise and safely support the vehicle and remove the left rear wheel.
    4. Remove the fuel pump cover bolts and the cover.
    5. Remove the fuel pump mount bolts and the fuel pump with it's mount.
    6. Disconnect the fuel hoses and the electrical connectors.
    7. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the system and check for leaks.

    1990-93 Integra and Vigor
    See Figures 2 and 3
    1. On Integra, remove the rear seat and access panel and disconnect the wiring.
    2. Remove the fuel tank.
    3. Remove the pump flange mounting nuts and lift the pump out.
    4. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the systemhow can i get to the fuel pump on a 92 a - 0900c15280049850.jpg.



    0900c15280049850.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Fig. 2: Removing the fuel pump access cover-Legend and Vigor


    0900c15280049851.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Fig. 3: Removing the fuel pump assembly-Legend and Vigor
    Legend

    1. Disconnect the negative battery cable.
    2. Relieve the fuel system pressure.
    3. Remove the maintenance access cover in the luggage area.
    4. Disconnect the fuel lines and the electrical connectors.
    5. Remove the fuel pump from the fuel tank.
    6. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the system and check for leaks.

    Posted on Nov 09, 2012

    Ad

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
    click here to download the app (for users in the US for now) and get all the help you need.
    Goodluck!

    Posted on Jan 02, 2017

    Ad

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    How do you get to the fuel pump on 1992 Acura vigor


    Unfortunately you have to remove the fuel tank,the pump is in it. It isn't that hard to remove on a lift, and if it is close to empty, it might not be too hard on jack stands and a second support on both sides, at the very least.

    Jun 22, 2015 | 1992 Acura Vigor

    2 Answers

    My 92 Acura Vigor turn over but wont start


    so need to find out if you have a spark or a fuel problem. do you hear the fuel pump when you turn the key. checking for spark is a matter of pulling a boot of 1 of the spark plugs and use an old spark plug and lay it on the engine so you don't get shocked when you have someone try turning the key. if you see spark over and over. I would suspect the fuel being the issue or something broke. did it run fine when you turned it off last.

    Mar 12, 2015 | 1992 Acura Vigor

    1 Answer

    Fuel problems


    could be as simple as a fuel filter if it is in the gas line or it could be your fuel pump or a pinhole crack in gasline good luck hope this was helpful

    Mar 07, 2014 | 1994 Acura Vigor

    1 Answer

    Dont know how to get to the fuel pump


    you have to drop the fuel tank down, only way

    1. Remove the fuel tank.
    2. Disconnect the connector from the fuel pump.
    3. Remove the fuel pump mounting nuts.
    4. Remove the fuel pump from the fuel tank.
    5. Reverse order to reinstall
    6. jayscott155_13.gif
      this is manual directions, not much but hope this helps
      Jay

    Jun 06, 2011 | 1994 Acura Vigor

    2 Answers

    92 acura vigor clutch replcd still wont go in gear


    Is all the air bled out of the hydraulics??

    I would then suspect a faulty clutch component.

    Was it like this before the overhaul??

    Mar 10, 2010 | 1992 Acura Vigor

    1 Answer

    92 Honda Vigor. The car was dripping oil and my


    of the oil ran out then you may have locked up your motor

    Jan 12, 2010 | 1992 Honda Accord

    1 Answer

    Location for fuel pump on a 92 acura vigor


    the fuel pump is inside the gas tank.

    Jul 08, 2009 | 1992 Acura Vigor

    Not finding what you are looking for?
    1992 Acura Vigor Logo

    Related Topics:

    269 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Acura Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8522 Answers

    Are you an Acura Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...