Question about 2004 Chevrolet Colorado

Open Question

Low idle sensor on 2006 chevy colorado

Low rpm idle

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
greg_margo
  • 1959 Answers

SOURCE: Cobalt not running at low rpm.......

All are possibilities but EGR valve makes the most sense. It's famous for causing poor idling and/or stalling at low RPMS. Best of luck.
Greg

Posted on Jun 18, 2009

Ad
  • 10 Answers

SOURCE: idle problem on a 2006 chevy trailblazer 4.2

The code indicates an issue with the Throttle Actuator control. This is a little motor on the throttle body that opens the throttle plates at idle. That control motor may be bad and thus, causing a low idle.

I hope this helps.

Posted on Jul 21, 2009

c17hydro
  • 2984 Answers

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

  1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
  2. Remove the left front wheel and wheelhouse liner.
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)


e44e83f.gif
  1. Disconnect the knock sensor (KS) connector.
  2. Detach the knock sensor (KS) from the engine block.
To Install:
  1. Attach the knock sensor (KS) to the engine block.
    • Tighten the bolt to 18 ft lbs (25 Nm).
  2. Connect the knock sensor (KS) connector.
  3. Install the left front wheelhouse liner and wheel.
  4. Fully lower the vehicle.

Posted on Sep 03, 2009

  • 15 Answers

SOURCE: low idle on chevy colorado

The best thing to do is run a trouble code check on it.
Other than that check for a vaccum leak, the EGR valve, or the idle air control valve.

Posted on Feb 05, 2010

  • 1 Answer

SOURCE: 2006 chevy colorado install brake shoes

how do you replace brake pads

Posted on Oct 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Chevy Colorado 2.8 4 cyl. Engine is surging under normal acceleration. It has about 85K.


Clean the MAF sensor and the throttle body. Plus the Idle air control motor. Use a toothbrush with brake clean. Just spray the MAF with brake clean both ways..

Oct 04, 2014 | 2006 Chevrolet Colorado

1 Answer

My 2006 chevy colorado 2.5 will high idle rpm 1000 when started which never did that. It only has 47,000 what could be wrong and why is it doing that?


could have a vacuum leak check all your vacuum line see if you feel or hear any air. do you have any engine light on if you do scan your engine get a code.

Feb 17, 2013 | 2006 Chevrolet Colorado

1 Answer

Code comes up as low rpm,s changed plugs and wires air filter and added injector cleaner to the gas still comes up low rpm,s but runs great


you have to remove the throttle body and clean it really good there is a small hole through the butterfly that usually gets plugged up with grime also remove the idle air control valve that needs cleaning while you have throttle body out. do this and clear your codes and i am sure you wont have a low idle again. in any case do not adjust the idle screw that is never the solution.

Nov 20, 2010 | 2006 Chevrolet Colorado

1 Answer

How do i change out the knock sensor on a 2006 chevy colorado


You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:
  1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
  2. Remove the left front wheel and wheelhouse liner.
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)


e44e83f.gif
  1. Disconnect the knock sensor (KS) connector.
  2. Detach the knock sensor (KS) from the engine block.
To Install:
  1. Attach the knock sensor (KS) to the engine block.
    • Tighten the bolt to 18 ft lbs (25 Nm).
  2. Connect the knock sensor (KS) connector.
  3. Install the left front wheelhouse liner and wheel.
  4. Fully lower the vehicle.

Sep 03, 2009 | 2006 Chevrolet Colorado

2 Answers

Cobalt not running at low rpm.......


All are possibilities but EGR valve makes the most sense. It's famous for causing poor idling and/or stalling at low RPMS. Best of luck.
Greg

Jun 18, 2009 | 2006 Chevrolet Cobalt

2 Answers

Rough idle


I had the same exact problem on my 2004 Colorado (3.5L). Cleaned the MAF sensor (with MAF sensor cleaner) and throttle body/plate - cleared it right up.

May 10, 2009 | 2006 Chevrolet Colorado

1 Answer

Why does my rpm gage bounce when i push my clutch in?


May be an iac motor slow to react to change in load. RPM will change when shifting or engaging/disengaging clutch. Does not sound serious yet ... If you can, compare with similar vehicle and see it it does the same.

Dec 20, 2008 | 2006 Chevrolet Colorado

1 Answer

I have 2006 Chevy Colorado with 2.8l vortex engine (standard), Idles great but when i am going down the road then push the clutch in to stop the RPM gage will go up and down from 700RPMs to around 300RPMs...


There is a recall for valve problems. The warranty for this problem has been extended to 100,000 miles for that. Check with your dealer to see if that is the problem. If no help contact GM.

Dec 20, 2008 | 2006 Chevrolet Colorado

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...