Question about Cars & Trucks

Open Question

2003 ford 4.6L code po775 - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replaced the engine in my 2001 ford explorer. since i have codes p0102 code p0113 code p0201 code p1504 and po775. do you have any idea what i need to do


http://www.explorerforum.com/forums/showthread.php?t=228242

This shows list of codes. You have so many faults hard to know where to start. Was new engine an EXACT match for the old one? If not, did you change ECM? Appears MAF is not connected or bad, and also #1 injector circuit is bad. Others also.

Jan 15, 2015 | 2001 Ford Explorer

1 Answer

2001 f150 4,6l motor replaced right side timeing chain car bearllyruns could this be caused by putting the crank shaft sensor in backwords


the camshaft keys should be positioned downwards at 90 degrees to the head surface(Gasket surface) This will place the timing marks on the sprocket in the 1o'clock position upwards. The black link on the chain will be aligned with the 2 dots on the sprocket. This applies to both heads. the crankshaft sprocket will be facing down and the black link will be on the single dot. The crankshaft keyway will be located at approx. the 11 o'clock position.

If this sounds a bit daunting then get a workshop manual as it explains the process well. The book says not to turn the camshafts /crankshaft with the chains removed and I suspect that if this is not adhered to then bent valves will result.

Sep 01, 2014 | 2003 Ford F

1 Answer

Code p0775


Anytime you get OBD Codes-- you Google them
& the solution

OBD PO775 & your vehicle

Aug 22, 2013 | Cars & Trucks

1 Answer

I have a 2003 mountaineer 4,0 with a 5R55E trans o/d light flashes trans wont shift into second unless u take the the gas pedal off code PO775 and P2195 once u let off the gas pedal it shifts in all t


PO 775 That is a Factory Code
You can Google it
There is enough to keep you busy a long
time if you can figure it out

Appears to be a Trans Solenoid issue
I don't know if they are individual or a entire
pack like my Lincoln LS

When you figure it out you can do yourself
Not all that hard


P2195 Lack of HO2S11 Switch,Sensor Indicates Lean

That should be your front oxygen sensor on the pass side

I would replace both upstream sensors-- if you failed to do
so at 100,000 miles,on all your vehicles,then you avoid at
least some problems

Dec 22, 2012 | Cars & Trucks

2 Answers

When i drive the o/d light is blinking and the chech engine light is on too and appear the code po775


P0775 - Pressure Control Solenoid B Malfunction

The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the Transmission Control Module (TCM). The P0775 is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve.

Possible Causes:
- Faulty line pressure solenoid B valve
- Line pressure solenoid B valve harness or connectors
- Line pressure solenoid B valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

Jan 20, 2011 | 2002 Ford Explorer

1 Answer

'92 Town car airbag indicator flashes, cruise control not working


you need to have a diagnostic done in order to get an error code and take it from there..

Sep 05, 2009 | 1994 Lincoln Town Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...