Question about Infiniti Cars & Trucks

Open Question

Where is the transmission dipstick on a Infinity I35

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hiseyj
  • 99 Answers

SOURCE: trunk won't open on 2004 infinity i35

Have you checked the trunk switch in the glove compartment to make sure it is on? Just a thought.

To remove the rear seats: there are two tabs for the rear seat bottom one on the left and one on the right, look at the front bottom of the seat cushion. Pull the tabs and lift up on the seat it should come out easily. Once the seat bottom is out you will have access to the mounting hardware for the seat back. Good Luck.

Posted on Nov 26, 2008

Mr BrokRench
  • 1623 Answers

SOURCE: 2002 infinity i35 i'm looking to buy one but on

Yes, this is a potential transmission rebuild due to low internal pressures, loose bands & worn clutches. I would not by this vehicle in this condition.

Posted on Sep 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 i35 infinity will not go past 2200 rpm


Might change the fuel filter. It might not be allowing enough fuel to the engine.

Aug 08, 2016 | 2003 Infiniti I35

1 Answer

2002 infinity i35 will not crank or turn over, yet dash lights work


The ignition switch could be defective but you don't mention in your narrative whether you had the starter checked

Jan 14, 2013 | Infiniti I35 Cars & Trucks

1 Answer

How do i check the transmission fluid level


let motor warm to operating temperature , Pull dipstick for tranny , clean off, insert back into hole again pull out read the bottom will show fluid level (do this with engine running

Sep 18, 2010 | 2007 Infiniti I35

2 Answers

How do i replace the camshaft position sensor on a 2004 infiniti i35


hi, i have infinity fx 35 2003 it light on the service engine camshaft position sensor bank 1 , i replaced the bank 1 after 3 hour it light on again service engine + VDC off and slip i put the scanner it told me camshaft position sensor bank 1 again what can i do ?

Jul 24, 2010 | 2004 Infiniti I35

3 Answers

Would an idle control valve cause a car not to accelerate?


no, idle air control valve is literally to control your idle speed.
what happen when you press on gas? car shakes, RPM goes up, or engine just bogs down?

Mar 09, 2010 | 2004 Infiniti I35

1 Answer

Is premium unleaded gasoline used in an infiniti I 35


Yes you can use Premium Unleaded Gasoline in your 2004 Infinity I35. Infinity actually recommends Premium grade gasoline for your car!

Oct 20, 2009 | 2004 Infiniti I35

1 Answer

Location of spark plugs


your engine is an v6, look for valve cover on each side of engine, note 3 ignition coils, the spark plugs is under each 6 ignition coils

May 02, 2009 | 2004 Infiniti I35

1 Answer

Put new rear rotors and pads on my 2002 I35 Infinity, now have very weak pedal , have to pump the brakes in order to stop, doesn't maintain pressure.


Doesn't sound like the brake lines were bled properly. Many times after pad and rotor installation if the lines are bled correctly you will have to pump them initially after the repair for a couple of minutes until the pressure is built back up. Also check the master cylinder and make sure fluid level is ok.

Apr 13, 2009 | 2004 Infiniti I35

1 Answer

Trunk won't open on 2004 infinity i35


Have you checked the trunk switch in the glove compartment to make sure it is on? Just a thought.

To remove the rear seats: there are two tabs for the rear seat bottom one on the left and one on the right, look at the front bottom of the seat cushion. Pull the tabs and lift up on the seat it should come out easily. Once the seat bottom is out you will have access to the mounting hardware for the seat back. Good Luck.

Nov 23, 2008 | 2004 Infiniti I35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14184 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...