Question about 2000 Buick Century
You must have the car put up on a rack and all the parts inspected, you have something that is bent and ruined is my guess. Insurance will cover this of course.
Posted on Nov 09, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: buick century 2000 wipers
I found the following description on the web, this covers a bunch of the questions I was going to ask...
I own a 2000 Silo and wondered the same thing and do see some GM vans with this problem.
When I bought mine I also bought the Haynes Repair manual (1997 thru 2001 all models GM) #38036 to learn how to fix this and a LOT of other components in/on the van.
For $20 it's worth it.
To answer your question: If the wipers stop at the position they're in when the switch is turned off (Fail to park), disconnect the multi-function switch electrical connector. (This is located under the dash next to the firewall and steering column)
If the wipers now park, replace the multi-function switch. If the wipers still do NOT park, check the wiring from the wiper motor to the switch for a short circuit. If the circuits are good, replace the wiper motor.
Note: There are other adjustments needed for proper operation than just bolting and new motor on.
You can have a look at this manual at any automotive parts supply store.
Posted on Dec 06, 2008
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
Posted on Jan 04, 2009
SOURCE: LOW TIRE PRESSURE WARNING LIGHT
Turn ignition to run position,go to fuse panel right hand of vehicle,push and hold reset button for 5 seconds,low pressure light will flash 3 times,start car it should turn off the low pressure light.
Posted on Jan 29, 2009
Tips for a great answer:
Jan 23, 2018 | Cars & Trucks
Sep 04, 2016 | Chevrolet 2004 Chevrolet Malibu LS
Mar 01, 2016 | Buick Cars & Trucks
Jun 19, 2013 | Cars & Trucks
Nov 09, 2012 | 2000 Buick Century
Jul 25, 2012 | 2003 Mazda 6
May 21, 2012 | 2000 Chevrolet Cavalier
Aug 19, 2011 | 2002 Buick Century
Jan 15, 2009 | 1992 Buick LeSabre
123 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: