Question about Chrysler PT Cruiser
Got a po430 codes nneed to know location of 02 sensor
The are in the exhaust system. You will need to know if it's bank 1 or 2 & sensor 1 or 2 in that bank.
Posted on Nov 09, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Both these codes relate to Catalyst efficiency below threshold on banks 1+2. This is normally caused by a combustion fault. This fault may be shown due to a faulty sensor in either air imput or exhaust systems, Get the memory read at a dealers or good garage. If you had a serious problem the car would not drive well.
Hope this helps - good luck.
Posted on May 12, 2009
Crankshaft and Camshaft Position Sensors
Camshaft Position Sensor
Engine timing is determined from the relationship between the crankshaft and camshaft. This relationship is maintained by a timing chain or timing belt. The Engine Management System does not control engine timing but it does monitor the relative position and speed of these shafts by monitoring signals generated by sensors. The Engine Management System (EMS) uses signals generated by the camshaft position sensor to synchronize fuel injection to the valve sequence and for the on-board diagnostic procedure for misfire detection. The EMS energizes the injector at or near the time the intake valve opens. For misfire diagnosis, the EMS compares the number of camshaft sensor reference pulses and the number of crankshaft position sensor reference pulses received. If the EMS receives an incorrect number of pulses Diagnostic Trouble Codes (DTC’s) should be stored in the EMS.
If the camshaft position sensor or circuit is faulty most engines will start. Some engine management systems will then default to a pre-programmed injector firing sequence. All injectors may be energized simultaneously or all of the injectors on one bank may be energized at the same time. If the CMP data is required for misfire detection and reliable CMP data is not present misfire detection would probably be suspended.
Related Symptoms The following symptoms can be caused by an intermittent wiring connection or faulty signal to the EMS:
In addition the EMS uses minute variations in the CKP sensor data to determine engine misfire. The EMS uses this information in conjunction with the camshaft position sensor to perform misfire diagnostics.
Related Symptoms: No Start/Intermittent Start Condition – Can be caused by a faulty crankshaft position sensor due to loose connections, bad grounds, high resistance in the circuit, or opens in the circuit
Posted on Jun 23, 2009
Check fuel pressure it should be 34psi and with vaccum removed from regulator it should be 43psi. Low fuel pressure can contribute to misfires.
Posted on Jul 26, 2009
Tips for a great answer:
Feb 18, 2015 | 2001 Nissan Maxima
Nov 06, 2013 | Cars & Trucks
Sep 05, 2012 | 1999 Lexus ES 300
Aug 09, 2012 | 2002 Nissan Sentra
Jan 27, 2018 | 2002 Chevrolet Silverado 1500
Jan 25, 2012 | Chevrolet 1500 Cars & Trucks
Apr 19, 2011 | 2004 Nissan Murano
Jul 25, 2009 | 1996 Nissan Sentra
Jul 24, 2009 | 1995 Nissan Sentra
Feb 28, 2009 | 1996 Nissan Sentra
232 people viewed this question
Usually answered in minutes!