Question about Cars & Trucks

1 Answer

My 2001 monte carlo ss caught a small engine fire today.what should I do and what could the problembe?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 689 Answers

Plan on a nice bill to have it repaired,

Posted on Nov 09, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: 2002 monte carlo ss

The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: Car Radio Problem

It is your amplifier.You can buy a $12.00 ,Amp Bypass Turobowire Harness.{12 VOLT-TRAVEL,

Posted on Dec 11, 2008

daves944
  • 1050 Answers

SOURCE: fix front wheel bearing 2001 monte carlo ss

Remove the wheel, remove the axle nut, remove the brake caliper and bracket, remove the brake disc, remove the three bolts that go through the back and hold the bearing assembly in the knuckle, disconnect the abs connector and slide the bearing assembly out. Reverse the procedure to install the new one.

Posted on Jan 07, 2010

c17hydro
  • 2984 Answers

SOURCE: crankshaft sensor on a Monte Carlo 2001 SS 3.8

3.8L Engine

  1. Turn OFF the ignition.
  2. Remove the serpentine belts from the crankshaft pulley.
  3. Raise the vehicle.
  4. Remove the right front wheel and tire assembly.
  5. Remove the right inner fender access cover.
  6. Hold the flywheel with a (J 37096) flywheel holding tool.
  7. Using 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
  8. Remove the crankshaft harmonic balancer, using a (J 38197-A) balancer remover.
  9. Remove the crankshaft position sensor shield (1). Do not use a pry bar.
  10. Disconnect the sensor electrical connector.
  11. Remove the attaching bolts from the crankshaft position sensor.
  12. Remove the crankshaft position sensor from the block face.
To install:
  1. Position the crankshaft position (CKP) sensor to the block.
  2. Install the bolts to hold the CKP sensor to the block face. Tighten the bolts to 14-28 ft. lbs. (20-40 Nm).
  3. Reinstall the crankshaft position sensor shield.
  4. Connect the CKP sensor electrical connector.
  5. Position the crankshaft harmonic balancer on the crankshaft.
  6. Hold the flywheel with a (J 37096) flywheel holding tool.
  7. Using a (J 36660-A) torque/angle meter, tighten the harmonic balancer bolt to 110 ft. lbs. (150 Nm), plus an additional 76 degrees.
  8. Install the right inner fender access cover.
  9. Install the right front wheel and tire assembly.
  10. Tighten the wheel nuts to 104 ft. lbs. (140 Nm.).
  11. Lower the vehicle.
  12. Reinstall the serpentine belts.

It looks like this:

fd368a5.jpg

Posted on Jan 10, 2010

jturcotte
  • 8531 Answers

SOURCE: how do i reset the

you need a scanner to clear the codes. make sure you have them written down first. Many parts stores offer free scans (autozone, Advance, etc.)

Posted on Sep 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i know if water pump is bad on 06 monte carlo ss 5.3


You can tell if it makes noise or leaks from a small hole in the bottom of the water pump.

Feb 09, 2015 | 2006 Chevrolet Monte Carlo

1 Answer

How do i replace oil pump on 01 monte carlo ss


If the oil pan will clear the steering components without jacking up the engine then drop the pan and unbolt the oil pump. You'll need to get a new pan gasket for the oil pan too.

Sep 25, 2014 | 2001 Chevrolet Monte Carlo

1 Answer

2001 Monte Carlo SS 92,000 have to add quart of oil every other month. Engine is very clean, no smell of burning old and no blue smoke and no leaks on the ground, Use total synthenic oil for high mileage...


No doubt valve seals,the oil gets burned so you usually can't see it.Normal for GM motors,actually the small amount of oil will help the longevity of the engine.They can be changed in a few hours but I would leave it alone.When they get really bad if the car sits and idles you will see some smoke. The seal is just a small o-ring ,they get brittle and fall off.The shop can use air pressure at the spark plug hole to keep the valve up,compress the valve spring and replace the seal.

Jan 29, 2011 | 2001 Chevrolet Monte Carlo

2 Answers

2001 monte carlo ss. has heat but heat gauge does not work and cooling fans do not cycle just keep running


Hi, check the connection on your temperature sensor. If the connection is good, replace the sensor. The cost is about $11 at autozone. The sensor is located at the back of the engine, near the transmission. See pictures below. Use some water pump sealant on the threads when installing the new sensor. Please let me know if you have any questions, and thanks for using FixYa.

3.4 liter engine:

jturcotte_648.gif

3.8 liter engine:

jturcotte_649.gif

Dec 28, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

Where exactly is the thermostat in my 2001 monte carlo ss.


follow your upper radiator hose to the engine block , see picture below
a32b353.gif

Oct 16, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

How do i reset the check engine light on my 2001 chevy monte carlo ss


you need a scanner to clear the codes. make sure you have them written down first. Many parts stores offer free scans (autozone, Advance, etc.)

Sep 23, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

2002 monte carlo ss


The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Feb 27, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

2001 monte carlo


do you have spark if you have no spark the crank sensor is bad.do you have fuel presure now. if not check the fuses. nead more info

Nov 23, 2008 | 2001 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...