Question about 2001 Hyundai Accent
Brakes locking up
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION 1. Check the pads for wear or oil contamination and replace, if necessary. • The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets. • All four pads must be replaced as a complete set. • When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material. 2. Check the pad for damage or deformation. Brake pad thickness: Standard value: 9 mm (0.354 in.) Service limited value: 2 mm (0.0787 in.)
INSTALLATION 1. Install the pad clips. 2. Install the pads onto each pad clip.
3. Insert the piston in the cylinder using the Special Tool (09581-11000). 4. Install the new pads. The shims are attached to each pad as illustrated Be careful so that the disc or pad isn't contaminated by grease. 5. Install the bolt and tighten to the specified value. Tightening torque Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
Posted on Jun 11, 2008
hot or cold engine !!
cold engine :- the problem in (ECT) engine coolant temperature
sensor or lose fuel pressure ??
hot engine :- (CKP) crankshaft position sensor or (ECT) too
explain more details abut your car default
and replay us for more information
WITH MY BEST WISHES
Posted on Jul 08, 2008
it should tell you on the cap of the oil what oil and start with 4 qrt and then let sit for a few minutes then chec dipstick usauly its 5 qrts
Posted on Jan 25, 2009
Once the car is jacked up, remove the front tires, then whith a 12 wrench key, remove the bolt that is located on the rear side of the caliper, not the one holding the brake fluid line buth the one right next to it. Pry the brake pad holder off and then remove the brake pads themselves. You will need to press the caliper's piston in, to be able to fit new brake pads since new pads will be thicker.
Posted on Oct 05, 2009
Tips for a great answer:
Oct 04, 2013 | 2002 Hyundai Accent
Dec 28, 2012 | 2001 Hyundai Accent
Nov 07, 2011 | 2001 Hyundai Accent
Feb 28, 2011 | 2001 Hyundai Accent
Oct 17, 2010 | 2001 Hyundai Accent
Oct 05, 2009 | 2001 Hyundai Accent
Oct 04, 2009 | Hyundai Accent Cars & Trucks
Jul 07, 2009 | 2001 Hyundai Accent
Jun 06, 2009 | 2001 Hyundai Accent
Jan 25, 2009 | 2001 Hyundai Accent
52 people viewed this question
Usually answered in minutes!