Question about Chevrolet Silverado 1500

1 Answer

4wd problem? on a 2002 chevy silverado with push button 4x4 when u put it in 4wd the light comes on like everything is fine and if in 4lo it has the low gear, but the front tires dont lock in and wont pull...no light or any codes

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

This is common in GM trucks since they started adding 'Autotrak' push button 4WD. I would drain and purge the transfer case fluid and replace with new. There should be drain and fill plugs. But it sounds like you might have a stripped gear. Might be a trip to the shop just to be safe.

Posted on Mar 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1997 GMC Sierra lights for 4hi and 4lo blink when i push the 4hi button and then goes back into 2hi. but when i push 4lo it locks in and works fine. I tried changing the 4wd motor on the transfer c


THE TRANSFER CASE MOTOR IS ONLY FOR 4WD LOW. That would have never been the problem as soon as you confirmed it shifted into 4wd Low. 2wd and 4 Hi work off of vacuum. You may have one or two issues. A vacuum leak up by the front axle that engages the 4wd HI or the sensors on the transfer case.

Nov 22, 2013 | 1997 GMC Sierra

1 Answer

02 chevy silverado 4x4 service light always on and stuck in 2 wheel drive.


You need to have the dealer scan the control module to see what codes show in memory

Jun 17, 2012 | 2002 Chevrolet Silverado 1500

1 Answer

How to put into 4x4 hi ?


If its a 4WD there is either a push button on the dash left side of steering colomn, its marked 4hi. If manual shifter in on floor center console. Pull back on lever to second notch marker 4hi. If you are in 4lo now and can't get out. first put tranny shifter in neutral while engine running, then shift transfer case into neutral (manual push forward), push button hold 4hi and 4lo at the same time til "N" green light comes on. Then shift either into 4hi.

Jan 27, 2011 | 2001 GMC Yukon

1 Answer

4x4 quit working


Jack up the rear wheels and put it on jack stands. Have someone get in it and put it in 4wd and drive. Release the brake. Rear wheels are spinning only right. Don't get under it but look under it and see if the front driveshaft is spinning. If the shaft is spinning but the wheels aren't it is likely a bad front axle actuator. If the front shaft isn't spinning it is a transfercase problem.

Jul 18, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

2003 chevy 1500hd 4wd transfer case problem


your gear box needs a good look .. could turn out expensive unless you can manage with patience.

Jun 28, 2010 | 2003 Chevrolet Silverado 1500

2 Answers

Vehicle: 2005 Chevy Silverado 2500HD 4X4 Duramax. Problem, when I trying switching the 4 wheel drive switch to 4LO, the light just blinks continuously.


You should have it put on diagnostic scanner to tell for sure. system needs to be tested. As a mechanic myself, I know these can be done fairlty easy on most vehicles but some can be slightly tricky

Aug 27, 2009 | 2004 Chevrolet Silverado 2500HD

1 Answer

2001 Chevy 4WD button lights don't come on - 4WD wont engage


check the solenoid on the front chunk these vehicles have had a lot of problems with these solenoids. have personally replaced about 10 of these on 98-02 models.

Aug 26, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

96 chevy 4x4. no ind lights. stuck in 4hi


Replace the selector switch assembly. Common failures.

Mar 27, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

2002 Chevy Silverado clunking noice when shift from 2wd to 4hi


It is somewhat Normal Depending on how Loud the Clunking is. This is a Common Complaint on the Chevy 4x4's. I have verified this through the Dealerships here in Oklahoma and they all say the Same thing But, I am with you, They should go into 4x4 without that Clunk for as much as we pay for them.

Jan 26, 2009 | 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

356 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...