Question about 2004 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica that hestates upon take off if it reaches 3000 RPMs. I have to slowly drive till I get enough speed without reaching 3,000 RPM so that it won't thump multiple times. My tire pressure & engine light light are on as well as service tire system messgae. My mechanic can not figure it out & he's had the car now for two months. Has anyone had same/similar issues?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Sorry you need a real mechanic. I need the codes that are you, it sounds like a transmission problem ,but can you get the codes please. here is my link

Posted on Nov 09, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 chysler pacifica at random points when driving it wont let me go over 2500 rpms

Sounds like your catalytic converter is clogged replace it and find the cause

Jul 21, 2015 | 2004 Chrysler Pacifica

1 Answer

Chrysler Pacifica 2004 heater won't power on. I bled the coolant of air and power came back on . but after it was at operating temperature and it stopped working. What do I do now?

some have an actual temp contol that stops when high end temp is reached..(or it slows way down) yours may be so equipted..check fuses also..

Dec 25, 2013 | 2005 Chrysler Pacifica

2 Answers

2002 Chrysler Sebring 2.7 liter... When the car starts, I can only bring the RPM's up to 3000. when I've reached 3000 rpms the RPM's start going up and down...I have replaced the fuel pump what should I...

Nothing, you have hit the rev limiter. The up and down is the computer controlling the rpm. If you drive it, it should rev past 3,000. The computer is designed to keep free wheeling rpm to that level. It will only allow a higher rpm if vehicle is in gear and moving with a load.

I’m happy to help further over the phone at

Oct 27, 2013 | Cars & Trucks

1 Answer

My 1997 Jimmy runs fine in idle when I take off the vechile is fine until it reaches 20 mph it won't accelerate and the rpms increase up to 3000 but no speed. What's wrong it's a 4 wheel d

Sounds like 2nd gear in the transmission is slipping. Cars usually shift at 15-20 mph from first to 2nd. First check the trans fluid.

Mar 17, 2013 | 1997 GMC Jimmy

1 Answer

I have a 2004 Chrysler Pacifica that hestates upon take off if it reaches 3000 RPMs. I have to slowly drive till I get enough speed without reach 3,000 RPM so that it won't thump multiple times. M

Personal experience says you have a wiring harness that is grounding out and causing the codes...This is especially true if you have had the typical motor mount issues that are common on the Pacifica...Check the wiring harness behind the drivers side wheel...

Remove the front left wheel (drivers side)
-Remove the wheel well shield (just the front is all that is necessary...fold it back)

-Verify the vehicle ground is still intact (when the motor mount gives there is not enough slack in the ground wire and the wire will pull out of the grounding lug)

-Inspect the wiring harness that is around the transmission that goes to the PCM (when the motor mounts give they can crush and then rest on the harness and wear through the casing and then affect the individual wires...throwing codes...)

Nov 08, 2012 | 2004 Chrysler Pacifica

2 Answers

After driving several miles my 2004 pacifica starts to beep - 3 beeps every 30 seconds and doesn't stop. No lights are on - engine or otherwise. Once I've stopped and the engine has been turned off for...

if you drive slowly does it not start? ensure you do not having anything resting on your passenger seat. if there is a weight sensor in the seat for the seatbelt warning the car assumes sombody is in the passenger seat. or the sensor is defective to isolate this plug the passenger seatbelt into its lock and see if the problem goes away. (when driving slowly this may not start. the alarm may be set to go of after a certain speed)

note: keep all clutter away from the driver position after cornering or breaking, debris may fall into the foot well and interfere with the pedal movement. or fall onto the driver.

Nov 13, 2009 | 2004 Chrysler Pacifica

1 Answer

How do u get to the low beam bulb to change it on the 2004 chrysler pacifica

Take out two screws above headlight under hood. Pull headlight forward remove rubber cap reach in with real small hands or needle nose pliers remove bulb with a twist. Insert bulb same way after you wipe it with alcohol replace rubber cap push back in and replace two screws.

Nov 02, 2009 | 2004 Chrysler Pacifica

1 Answer

Running at 3000 rpms

most likely a stuck overdrive shift solenoid or a faulty vehicle speed sensor.

Feb 13, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides