Question about Cars & Trucks

1 Answer

How long will it take to change the water pump on a 1996 saab 900s

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,363 Answers

I got this info. from automd.com,it says dealer and local shop take 1.3 hours and the do it yourself takes 1.7 hours, prices are 305.00 dealer,149.92 for local shop and 58.16 for the do it your self,these prices are quoted from my zip code.Yours may be different.

Posted on Nov 09, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
short shadey
  • 421 Answers

SOURCE: 1996 SAAB 900s ELECTRICAL SYSTEM Problem.

pull the drivers knee bolster and check for water under the dash and carpets, second remove the single to-rx screw holding the relay panel in place pull it down and be sure all the relays are tight wiggle them around i have gotten bad connections here that caused similar problems also check all the connectors under there and every plug into the back of the fuse relay panel, if that leads you no where you need to get a wiring diagram for each of these circuits and find their common place such as a ground or relay power please rate i will try to find my repair cd for these diagrams -jeffbest of luck and i will be back with diagrams -jeff

Posted on Sep 13, 2008

  • 4 Answers

SOURCE: Replacing ignition switch on Saab 1996 900s 2.3 I 5 speed

You take all the center console and plastic ducts from between the seats. There are 4 10mm bolts holding the shifter mechanism to the floor. Take these off and do your best to flip the whole housing to where you can access the bottom side. The ignition switch is attached under there. As I recall there are 2 T20 screws holding it on.

Posted on Nov 07, 2008

Saaboheme
  • 76 Answers

SOURCE: How do I change the

The Saab accessory drive (serpentine) belt is self-tensioning by means of a tensioning pulley. Excessive play means that the current belt is spent and must be replaced. It is a very good idea to replace the idler pulley above the tensioner pulley at this time as the bearings fail over time. You can get an aftermarket pulley of machined billet aluminum construction with a repalceable bearing race from Wazee Pulleys. This pulley is superior to the stock one in just about every conceivable way.
To remove the belt you will need a 1/2 inch socket extension bar that will fit exactly in the top of the tensioning pulley housing and a six mm allen key. This site shows the proper routing of the stock belt and the routing procedure to bypass the highly failure prone center idler pulley if you so elect, as well as the procedure to remove and fit a new belt. Note, the belts shown on this site are for the short-belt modification only. The stock replacement belt is Part Code: 4904728 Brand:
Description: Serpentine belt for any 94-98 NG 900 4cyl. Price: $35.90 at Eeuroparts.com.
To remove the belt, you will find it best to remove the airbox to allow you more room at the top end to work. Also, jack up the car and remove the passenger wheel to give you access down below.

Posted on Dec 16, 2008

  • 5 Answers

SOURCE: 1997 saab 900S airbag worning light on

There are lots of sensors in your car that tell the Airbag Module that you are in the seat.
The seatbelts also have sensors in them and are known for going bad. Run down to your local autozone and they will have something to hook up to it to find the code that the Airbag set.That will lead you in the dirrection you need to look in. (Important) YOUR AIRBAG WILL NOT DEPLOY WHILE THE LIGHT IS ON IF YOU ARE IN A ACCIDENT

Posted on Jul 12, 2009

  • 4340 Answers

SOURCE: where is the thermostat in a 900s oh. 97 saab 900S

Oil change interval has nothing to do with operating temperature. If your coolant is full, feel the upper radiator hose, when the vehicle is up to temp. if cool , thermostat is back from that hose,

Look for air bleeds, and read owners manual, some cars have coolant bleeds. Also, heater on high when filling coolant or risk bubbles...

My thought is that your fans may not be kicking in. They should cycle on and keep temp low enough. test them.

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i first start my car theres a high pitched whining/whirring noise on saab 900s, what is that? starter problem or a belt or pulley?


The accessory belt idler pulley bearing is on the way out. Get it replaced. You will not be able to drive the car if it fails, since that belt drives the power steering, water pump, and the alternator.

May 15, 2012 | 1996 Saab 900

1 Answer

1996 saab 900s starts but turns off


Failing crank position sensor (CPS) is possible. If the ECU does not get a constant pulse from the CPS the fuel pump does not switch on, so no start due to no gas. if it is failing, the pump may activate intermittently.

Apr 27, 2012 | 1996 Saab 900

1 Answer

Saab 900s convert air box exploded bad miss fire


learn the hard way ,,, it will need the attention of a mechanic to change all the parts burnt when it backfired and caught alight ,or just write it off and call the scrapyard

Aug 01, 2010 | 1996 Saab 900

1 Answer

Locating fuel pump relay


should be up on the firewall looks like a horn relay

Apr 22, 2010 | 1996 Saab 900

1 Answer

Location of windshield washer on 1997 saab 900s


you know where the windshield washer fluid tank is ? if so remove it the windshield washer pump is located at the bottom of it.

Jan 07, 2010 | Saab 900 Cars & Trucks

1 Answer

1995 Saab 900S keeps leaking power steering fluid- need to know how to do it yourself troubleshooting.


First look on the ground for visible sings of fluid you may be able to located it that way if not start at the pump and follow the lines (there will be two, a high and low prssure line) to the rack visually inspect pump, lines and rack.

Oct 19, 2009 | 1996 Saab 900

2 Answers

Where is the fuse relay for fuel pump on saab 900 owners manual says its under steering wheel below instrument panel but i cant find it


The fuses for classic Saab 900s are located under the hood on top of the fender driver's side. This includes fuel pump fuse.

Apr 19, 2009 | 1996 Saab 900

1 Answer

Replacing ignition switch on Saab 1996 900s 2.3 I 5 speed


You take all the center console and plastic ducts from between the seats. There are 4 10mm bolts holding the shifter mechanism to the floor. Take these off and do your best to flip the whole housing to where you can access the bottom side. The ignition switch is attached under there. As I recall there are 2 T20 screws holding it on.

Oct 08, 2008 | 1996 Saab 900

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...