Question about 2003 Bentley Continental GT

1 Answer

How to replace spark plugs on bentley continental gt 2005

Do you need to remove the inlet manifolds to gain access to spark plugs

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.

  • Contributor
  • 27 Answers

You have to pull the intake off of the top of the engine. and then pull each coil pack with a special tool, and then remove the sparkplugs all 12 of them. then you will have to torque to proper spec. and reinstall the coil packs( there was a recall for certain coil replacement for causing a fire). and then put a new gasket on for the intake and then install the intake to proper specs.
hope helps...

Posted on Apr 08, 2014


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 837 Answers

SOURCE: I'm looking for a bentley continental GT 2005 repair manual

Here are some

Posted on Mar 11, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to open the bonnet on bentley 2005 when the cable is released

sometimes you can thump the bonnet and they release , means it needs oiled

Sep 27, 2016 | Bentley Continental GT Cars & Trucks

1 Answer

2005 Bentley Continental GT rear drivers side window not going up all the way

with respect, if you can afford a Bentley, you can afford to have it serviced. You are not going to be able to fix it yourself as it involves removing the internal panel and working through the holes in the door to find out if the glass has come loose, or whether it is a switch problem inside the door.

To make the car safe short term, have someone lower the window completely and then have a second person hold both sides of the glass with the door open and help the glass rise into the upper track.

Mar 09, 2016 | 2005 Bentley Continental GT

1 Answer

Wgolf.mk4.reg2000.removing upper part inlet manifold.

If you have a 2000 VW Golf 2.0 liter, the answer is yes. Just remove the top part of the intake manifold. A magnet and long handle allen key set will make the job easier for removing/ reinstalling the cap screws. Once manifold off, cover the intake holes with blue painters tape, to avoid dropping any thing down in them. Take care on plug wire removal. Change each plug one at a time. ***Tighten spark plugs with a torque wrench, spec 22 ft-lb in the Bentley manual. AEG, AVH, AZG eng codes***

Jul 08, 2014 | 2000 Volkswagen Golf

1 Answer

Change battery key remote" within Bentley 2005

The lithium ion cell in your key fob is dead and needs to be replaced. If you do not replace it soon, you will not be able to start your car.

May 22, 2014 | 2005 Bentley Continental GT

1 Answer

Can you tell me the location of the air conditioning pressure sensor on bentley 2005 continental

Hi there, it should be near the receiver drier or the condenser usually , why do you think it's a pressure switch problem ?

May 19, 2014 | 2003 Bentley Continental GT

1 Answer

How do I remove the left battery on a 205 Bentley Continental GT

I have the same problem..Called dealer who told me yuu need to remove fuse panel above and disconnect all the wires on the positive lead bracket to be able to puch out of the way. Also there is a small metal tiedown on the panel in front of the battery panel that needs to be unscrewed to allow that panel to be moved forward a little...I will try the replacement this weekend and see how it goes...

Dec 22, 2012 | 2003 Bentley Continental GT

1 Answer

I can not find the plugs so I can change them. or the plug wires

Your car doesn't have plug wires. Each plug has their own coil mounted on top of it. The plugs are right next to the fuel injectors on the intake manifold. Disconnect the wires at the coil and remove the 7mm headed retaining bolt. Twist the coil a bit to free the boot and remove the coil. Using compressed air blow out the debris in the spark plug hole and remove the spark plug. You will have to remove the air intake tube to gain access to the drivers side plugs.

Jul 02, 2010 | 2002 Lincoln Continental

Not finding what you are looking for?
2003 Bentley Continental GT Logo

477 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bentley Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

76164 Answers


Level 3 Expert

902 Answers

Are you a Bentley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides