Question about GMC Acadia

Open Question

Gmc p0496 p0171 p0174 - Acadia GMC Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: diagonostic trouble codes reported p0171

P0171 is system too lean bank 1, P0174 is too lean bank 2, and 302 is misfire bank 1. Look for vacuum leaks. If you don't find them, put a vacuum gage on it can check. The P0171 is almost always a vacuum leak. If not other possibilities are front O2 sensor is too old and should be replaced (if mileage is greater than 100k then replace). Try injector cleaner. Misfires are usually bad spark plugs, but could possibly be caused by insufficient fuel. I've never had a car of mine in bad enough shape to have that error.

Posted on Oct 24, 2008

Ad
bschilz
  • 2049 Answers

SOURCE: p0171 and p0174 codes

P0171 System too Lean (Bank 1)
P0174 System too Lean (Bank 2)

If a car has a check engine light on and has P0171 and P0174 codes stored, the most likely cause is a vacuum leak. These codes are set by the car’s computer when it sees too much oxygen in the exhaust. Excessive oxygen readings in the exhaust will set lean codes. This does not mean that the oxygen sensors are defective. It is a common mistake for people to replace oxygen sensors when lean codes are present. Just because the code is related to oxygen sensor readings, it doesn’t mean that the oxygen sensors are bad. If both of these codes are stored this means that both banks of the engine have excessive oxygen in the exhaust. If the oxygen sensors are replaced it’s most likely that the same codes will reappear. It is very uncommon for two oxygen sensors to fail at the same time.

Therefore the most likely cause of P0171 and P0174 codes is a vacuum leak. The source of a vacuum leak can be one of many things. The most common cause of a vacuum leak is a leaky hose. Vacuum hoses over time can become dry and brittle. The rubber deteriorates and can leak causing a vacuum loss. Many times a leaky vacuum hose can be found by listening for a hissing sound. A large vacuum leak can even make the car run rough at idle. In some cases it will not idle without feathering the gas pedal.

Posted on Sep 10, 2009

  • 1 Answer

SOURCE: Codes P0171, and P0174 bLean on a 98 Navigator. Any ideas?

mass air flow sensor is not the problem, I had the exact same problem and have done much research on this. Check the PVC rubber hoses, especially the elbows for cracks. You probably noticed your gas mileage has been horrible too. Hope this helps

Posted on Sep 16, 2009

  • 6 Answers

SOURCE: codes p171 and p0174 on a chevy truck?

Subject: 97-05 Vehicles with 4.8 5.3 5.7 and 6.0 Gen III V8 Engines and Misfires on One Bank - kw CEL diagnostics driveability DTC P0171 P0172 P0174 P0175 P0300 P0301 P0302 P0303 P0304 P0305 P0306 P0307 P0308 #PIP3056 - (07/12/2004)

Models: (00-05 Cadillac Escalade - C6 and K6) and (02-05 Chevrolet Avalanche - C1, C2 K1 and K2) and (99-05 Chevrolet Silverado - C1, C2 K1 and K2) and (00-05 Chevrolet Suburban - C1, C2, K1 and K2) and (00-05 Chevrolet Tahoe - C1 and K1) and (99-05 GMC Sierra C1, C2 K1 and K2) and (00-05 GMC Yukon - C1, C2, K1 and K2) and (03-05 Chevrolet Express G1, G2, G3, H1, H2 ) and (03-05 GMC Savana G1, G2, G3, H1, H2 ) and (04-05 Buick Rainier S1, T1 ) and (03-05 Chevrolet Trail Blazer EXT S1, T1 ) and (03-05 GMC Envoy XL XUV S1, T1 ) and (03-05 Hummer H2) and (04-05 Cadillac CTS-V DB) and (98-02 Chevrolet Camaro FB) and (97-04 Chevrolet Corvette YB) and (98-02 Pontiac Firebird FB) and (04-05 Pontiac GTO VB)

The following diagnosis might be helpful if the vehicle exhibits the described symptoms.

Condition/Concern:
Check Engine Light with a P0300 due to 2 - 4 cylinders misfiring on the same bank of the engine. DTCs P0171, P0172, P0174 or P0175 may also set for the misfiring bank.

Recommendation/Instructions:
If the published misfire diagnostic does not isolate the cause, perform the following suggestions as necessary:

  • Perform a fuel injector balance test for all 8 cylinders. If a fuel injector concern exists, it is possible to misfuel an entire bank of the engine, causing multiple cylinders on the same bank to misfire even though the root cause is a single fuel injector.
  • Inspect O2 sensor connections on the misfiring bank for corrosion or water intrusion. If water intrusion is found on the right bank, it may be due to the AC Evaporator Condensation dripping onto the O2 sensor harness. If this condition is found, reposition and shield the harness to prevent a repeat concern and repair the connections.
  • Check for excessive exhaust backpressure using the restricted exhaust diagnosis.
  • Swap the Position 1 O2 sensors side to side to see if the misfires move to the other bank of the engine. If so, replace the O2 sensor.
Please follow this diagnosis process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

NOTE: GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition.

Posted on Sep 30, 2009

  • 30 Answers

SOURCE: poor idle dtc P1151, P1131,P0174, P0171. runs ok

Change plugs, and Mass Air Flow sensor. This should do the trick

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 gmc envoy,check engine light keeps coming on,the code says it's a vacum leak,my ? is how common is this and where would i start?


What is the code ? No code specifically say's there is a vacuum leak . P0171 - P0174 lean condition ! Could be caused by lack of fuel as well , plugged injectors , fuel filter , low fuel pump pressure etc...
How to Diagnose OBD II Fault Codes P0171 and P0174 Leaking Intake and EGR...

Mar 23, 2017 | GMC Cars & Trucks

1 Answer

2001 GMC SIERRA 1500 4X4 CODES P0171 AND P0174 CHECK ENGINE LIGHT IS ON WONT PASS EMISION


Sometimes this is NOT a O/2 sensor issue ,,,,,If the P0171 is combined with the P0174 code, it's very likely that the problem is caused by an intake leak. If there are no intake leaks, the next step is to replace the air filter and clean the air flow meter. If the problem persist the front oxygen (O2) sensor may need to be replaced.
The P0171 code could also be caused may be caused by one or more of the following: debris on MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure or Engine Control Temperature (ECT) Sensor reading inaccurate,,,,,

Mar 24, 2015 | GMC Cars & Trucks

3 Answers

Code p0171 and p0174


P0171 possible cheap fix

Feb 21, 2015 | 2002 GMC Sierra 1500

1 Answer

What are the probable causes of DTCs P0171, P0174, and P0455?


Smoke testing for codes P0171 P0174 - YouTube

? 5:48
www.youtube.com/watch?v=kZsqEfP-5zM
Jan 18, 2011 - Uploaded by realfixesrealfast Smoke testing for codes P0171 P0174 .... I have a 1995 ford mustang gt 5.0 and it keeps having a Fault code 176 pop up. ....Ford Explorer P0174 code intake air leak check engine light by froggy - Duration: 16:11. by froggy ...

Sep 27, 2013 | 1999 Ford Explorer

1 Answer

2004 x-type 3.0 v6 152,000 miles showed codes P0171, P0174, P2096, P2098, P0101, P0171 pd, P1000.


check for vacuum leaks or a faulty mass air flow sensor. all the codes have to do with engine too lean(too much air).

Jun 09, 2012 | Cars & Trucks

2 Answers

I have a 2001 Jimmy with "Service Engine Soon"


P0171 System too lean bank 1
P0174 System too lean bank 2

Last time you changed your fuel filter?
Look for any vacuum leaks.

Sep 05, 2011 | 2001 GMC Jimmy

1 Answer

2002 gmc sierra p0171 p0174 p0300 oygen sensor and misfire codes


Check for vacuum leaks to start. Then check the evap system. I just replaced a evap vent solenoid on a suburban with the same codes. fixed the problem.

Apr 17, 2011 | 2002 GMC Sierra 1500

2 Answers

P0313;Misfire Detected with low fuel P0171-System too lean{bank1} P0174 System too lean{bank2} drive cycle


P0313 - Misfire Detected with Low Fuel
P0174 -System too Lean (Bank 2).
P0171 -System too Lean (Bank 1).

P0171 and P0174 mean "system too lean" for banks 1

Aug 24, 2010 | 2000 BMW 3 Series

3 Answers

P0171, P0174


po171 fuel injection system to lean bank 1 po174 same thing but bank 2 that could be the oxygen sensors

Apr 04, 2010 | 1997 GMC Jimmy

2 Answers

Yukon Denali Fuel Trim bank One and Two running too lean?


Could also be fuel filter, pressure, vacuum leak, etc. Check these two articles out, they should help too - http://www.obd-codes.com/p0171 and http://www.obd-codes.com/p0174

Dec 21, 2008 | 2002 GMC Yukon Denali

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

786 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...