Question about 2006 Jeep Commander Limited

Open Question

Lights are flickering in 2006 jeep commander

I turn on my head lights and they turn on and off on their own as well as the inside lights of the car. I dont know what it can be besides an electrical problem.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

greg_margo
  • 1959 Answers

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

  1. Raise and safely support the vehicle.
  2. Remove the rear wheel.
  3. Siphon a small amount of brake fluid from the master cylinder reservoir.
  4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
  5. Remove the caliper slide bolts.
  6. Remove the caliper from the anchor.

    WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
  7. Remove the brake pads from the caliper.
To install:
  1. Install the brake pads onto the caliper.
  2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
  3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
  4. Install the rear wheel.
  5. Lower the vehicle.
  6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
  7. Refill the brake fluid reservoir to the proper level.

Posted on May 17, 2009

  • 432 Answers

SOURCE: 2006 4.7 Jeep Commander Overheating

Can you see the cooling fans come on? When the engine gets to 212 degrees the fans should come on. To test the fans, with the engine running turn the A/C on high, the fans should come on .
The system also has a 212 switch that screws into the intake manifold. This is what turns on the fans with no A/C.
I hope this helps you.

Posted on Sep 06, 2009

  • 645 Answers

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Posted on Feb 13, 2010

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

Gozer
  • 435 Answers

SOURCE: install a altenator for a 2006 jeep commander

I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

Posted on May 21, 2010

  • 1 Answer

SOURCE: 2006 Jeep Commander Intermittent Starting Problems

Common problem in snow country where salt water can corrode starter parking gate wire connection at started tab. Just cleanthe connector and tab, coat in dielectric grease, problem solved in 15 minutes!

Posted on Dec 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal stays on a2006 jeep commander


Your turn signals are controlled by a electronic control module .The integrated power module . The switch is off an the turn lamp stays on ? No Low Beam Head Lamp Chrysler Pacifica Check out this guy's video , I know it's no same vehicle as yours ,but it's a Chrysler an jeep is the same manufacture. Chrysler Pacifica TIPM Electrical Problems .

Nov 30, 2015 | 2006 Jeep Commander

1 Answer

Headlight fuse


if you have an owners manual look inside of it that should tell you were the headlight fuse or fuses are located.. if you don't have the owners manual look on the inside cover of the fuse box there will be a diagram showing which fuse it is.. please be sure to give your feedback thank you I hope this helps

Apr 26, 2013 | 2006 Jeep Commander

1 Answer

Warning lights go on and off....2006 jeep commander


that code means the computers are not communicating

Aug 21, 2012 | 2006 Jeep Commander

2 Answers

2006 jeep commander makes a clicking noise when I turn ignition, all lights and radio come on but car won't turnover, what is it?


I have had this issue 2 times, both times it was the battery having damaged/dead cells. You can sometimes get it to start by putting your foot on the break, turning the key to the on position, putting the car in neutral then starting it. I purchased my Commander new in 2006 and have had to replace the battery 2 times since, both times this was the initial symptom. I have 120K miles and still love my Commander

Mar 06, 2011 | 2006 Jeep Commander

1 Answer

Head light flickers


turn headlights on and try moveing the wires by the head lights allthe way up battery and fuse boxes also check grounds by the lights if all looks good replace head light swicth.

Sep 13, 2009 | 2002 Jeep Liberty

1 Answer

How do you turn the passenger air bags on in a 2006 Jeep commander?


it's weight activated. I believe anything over 25? pounds will turn it on - you should see the light go off once something of that weight is in the passenger seat

Aug 05, 2009 | 2006 Jeep Commander

Not finding what you are looking for?
2006 Jeep Commander Limited Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...