Question about 2000 Jeep Grand Cherokee

Open Question

1996 jeep cherokee check gauges light is on - 2000 Jeep Grand Cherokee

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 1996 jeep Cherokee sport all

Check VSS Vehicule Speed Sensor wire may be corroted, bad connection or faulty; if 2wd the adaptor is located on the extension housing of the transmission (left side)
if 4wd look on transfer case extension (left side)

Good luck

Posted on Sep 25, 2008

  • 2 Answers

SOURCE: 1996 Jeep Grand Cherokee Electrical problem

You may want to have the wiring harness inspected. A major section under the fuse box(hood on 96 GC 4.0) may become chafed by a close proximity AC gas hose connector. My mechanic said it was slowly chewing at the harness. It caused me fuel pump problems, but your intermittant problem could be similar.

Posted on Oct 03, 2008

clarktravis8
  • 74 Answers

SOURCE: dash and shifter lights in 1996 jeep cherokee wont light

Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.

Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country

01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers

This should get you going. And you can always Ask Me.

Posted on Apr 27, 2009

  • 1 Answer

SOURCE: 1996 Jeep Cherokee electrical schematics and 1998 jeep cherokee

I need the bulb for the roof light for the 1996 Cherokee

Posted on Apr 28, 2009

  • 6 Answers

SOURCE: In my 1996 jeep grand cherokee the oil pressure

might want to check the ignition control (the key) did same to me but with volt gauge

Posted on Jun 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 jeep cherokee has low oil pressure after changing the oil


did you use correct oil weight could be sending unit. high miles?

Mar 02, 2012 | 1996 Jeep Grand Cherokee

1 Answer

Ihave a 1996 Jeep Cherokee on which the gas gauge has stopped working. Can the gauge be fixed or replaced?


check this website out: http://www.aa1car.com/library/fuel_gauge_diagnosis.htm

Oct 20, 2010 | 1996 Jeep Cherokee

1 Answer

1996 Jeep Cherokee, straight 6cyl, new fuel pump and now it is struggling running and pushing to much fuel. How do check fuel regulator, or where is it located? Thanks


the reg is most likely on the fuel rail. perform a pressure test with a fuel pressure gauge. attatch the gauge to the test point on the rail(looks like a vavle stem on the wheel), start engine and measure pressure. you must get the specs for pressure for your vehicle.typicly between 30 and 50 shut the vehicle off and leave the gauge attached. the pressure should hold. is the check engine light on?

Feb 25, 2010 | 1996 Jeep Cherokee Country

1 Answer

"check gages" light


the check gauges light is to tell you to look at the gauges,one of them is not in normal position,could be temp,oil pressure,charging,or gas.

Jan 12, 2010 | 1996 Jeep Grand Cherokee

1 Answer

My check gauge light came on and next day 1996 jeep grand cherokee would crank but didn't start.


I know this is the obvious question, does it have fuel? Usually Check Gauges is for Low Fuel, Low Oil Pressure , and such. Hope this helps

Jul 29, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Gauges fail to work n 96 jeep cherokee


check your ingitoin switch (the key) did it to me on volt gauge wouldnt work ding go dead and check guage light would come on

Jun 02, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...