Question about 2003 GMC Yukon Denali
Check for engine rpm signal, sounds like a cam/crank shaft position sensor issue.
Posted on Jul 23, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Did u put in fuel shortly before the light came on? I own 2 service centers & the most common situation with "Check Engine" lights are because the fuel cap wasn't re-installed or not tightened. When you refuel make sure it "clicks" when putting back on. We don't charge for a "Code Reading" but a dealer will, don't go there. Go, like the others suggested. If it is the fuel cap & you re-install it correctly, the light will go off after a short drive. Good Luck. PS-Don't panic when the "Check Engine" light comes on unless it blinks, if that happens don't drive. PSS-RE: Murray's, Auto-Zone.......If it's a "Code" (the reader will give a #) the code book will tell you the problem. PSSS-Some1 please have Troy W's Mommy & Daddy take away his keyboard. Just because you can put together a "Lego" car doesn't make you a master mechanic. You only repeated what we said except you have a "Napoleon" complex against any1 plugging something in to a vehicle. It's the same as plugging in a light @ home. In conjunction with "kinder" nine out of ten time in my experience it usually is the oxygen sensor(s) which would be about right with the year model
Posted on May 18, 2008
There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.
The ohter is under the dash and above the pedals, this one is much tougher to access.
Your Owner's Manual should tell you where the fuses are that you need to access.
Posted on Oct 20, 2008
it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you
Posted on Mar 16, 2009
2002 GMC Yukon Car Stereo Wiring Guide
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
Posted on May 24, 2009
See GM TSB 05-08-143-001, If you have Adjustable pedals, especially if they don't work with the memeory buttons, but function with thier own buttons. Its the Brake Pedal Position Sensor is shorted and mesing up the seat module which controls the heaters too. My 05 Suburban had the same issue
Posted on Dec 11, 2009
Tips for a great answer:
Jan 26, 2016 | GMC Cars & Trucks
Jul 29, 2014 | 2001 GMC Yukon Denali
Dec 11, 2012 | 2003 GMC Yukon XL
Feb 09, 2011 | 2003 GMC Yukon Denali
Dec 18, 2010 | 2003 GMC Yukon Denali
Jun 11, 2010 | 2003 GMC Yukon Denali
May 18, 2009 | 2003 GMC Yukon Denali
Jan 05, 2009 | 2003 GMC Yukon Denali
216 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: