Question about 2006 Subaru Legacy 2.5i

Open Question

Throttle position sensor 2006 legacy - 2006 Subaru Legacy 2.5i

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1114 Answers

SOURCE: how do you install a

take out screws or bolts unplug it and reverse method upon installation! do you even know its location?

Posted on Dec 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is a 2006 dodge charger throttle position sensor located


should be on the passenger side of the throttle body. If you look under the hood, where the throttle cable is attached to the drivers side of the throttle body, it should be on just the opposite side of the throttle body.

Apr 21, 2013 | 2006 Dodge Charger

1 Answer

2006 chevy monte carlo 3.5 v6 tps replacement


A THROTTLE POSITION SENSOR (TPS) is usually located on the butterfly spindle so that it can directly monitor the position of the throttle valve butterfly.
Throttle actuator control(TAC), that code comes from that part of the system too.

7gigkaaaaasuvork5cyii=
Throttle body showing the sensor on the right.

Feb 07, 2012 | 2006 Chevrolet Monte Carlo

1 Answer

How do you replace a throttle position sensor on a 2006 Chevy Aveo


seddy29732_0.jpgThis is a picture of your throttle position sensor. It is located on the throttle body, where the air inlet tube enters the intake manifold. Simply unplug the wires, remove the bolts holding it in place, and replace it with the new unit. Hope this helps!

Jun 02, 2011 | 2006 Chevrolet Aveo

1 Answer

1995 subaru legacy at 1 on the rpm gauge moving or in park it wants to stall out after it go pasts 1 it will drive okay.. but before it will wanna kept cutting out


it might be a bad TPS (throttle position sensor). it operates similarly to a volume control knob on a radio. as you accelerate the butterfly on the throttle body opens to allow more air into the engine, as you would turn up the volume on the radio. there could be "flat spot" on the sensor. they can be checked with a scan tool with real time display. if the sensor is bad it needs to be replaced.

May 03, 2011 | 1995 Subaru Legacy

1 Answer

Code p2120 and P2125 on GMC Yukon 5.3 2006 with low engine power message. can you please tell me whats that .


OBD-II code P2120 What does it mean? Throttle/Pedal Position Sensor/Switch "D" Circuit

Poooooooooo2125
ThrottlP2125
ThrP2125
Throttle/Pedal Position Sensor/Switch "E"ottle/Pedal Position Sensor/Switch "E"e/Pedal Position Sensor/Switch "E"

May 27, 2010 | 2006 GMC Yukon

1 Answer

I have a 2006 BMW 750li, removal of gas pedal


IF YOU ARE GETTING A THROTTLE PEDAL POSITION SENSOR FAULT CODE.THE THROTTLE POSITION SENSOR IS THE WHOLE THROTTLE BODY UNIT IS THE THROTTLE POSITION SENSOR.THE SENSOR NOT IN GAS PEDAL LIKE VOLKSWAGON. VOLKSWAGON HAS THE ACCELERATOR PEDAL POSITION SENSOR.

May 16, 2010 | 2006 BMW 750Li

2 Answers

Throttle position switch. how much for the part? is it easy to repllace?


This sensor sends the ECU an output signal which corresponds to the opening of the throttle valve. Using this output signal, the ECU precisely controls the air/fuel ratio during acceleration, deceleration and idling. The TP sensor and the throttle switch are combined as part of an assembly. The switch signal turns ON only when the throttle is opened to the idle position or at Wide Open Throttle (WOT) acceleration.

REMOVAL & INSTALLATION
( see Figures 2, 3, 4 and 5 )


76eea07.jpg

Fig. 2: Disconnect the wire harness from the throttle position sensor-Legacy

9b5eb25.jpg

Fig. 3: Paint a matchmark on the sensor and throttle body for ease of installation and adjustment

53c335f.jpg

Fig. 4: Remove the sensor retainer screws

f9a1aec.jpg

Fig. 5: Lift off the throttle position sensor
  1. Disconnect the negative battery cable.
  2. Disconnect the throttle sensor electrical harness.
  3. Place a matchmark on the throttle position sensor and throttle body mounting surface, so that during installation, the sensor can be properly aligned.
  4. Remove the 2 screws securing the throttle sensor to the throttle body assembly.
  5. Remove the throttle sensor by pulling it in the axial direction of the throttle shaft.
  6. Remove the throttle sensor O-ring and discard.
To install:
  1. Using a new throttle O-ring, install the throttle sensor, aligning the matchmarks. Install and hand-tighten the retainer screw.
  2. Connect the throttle sensor electrical harness.
  3. Connect the negative battery cable.

Hope this help (remember rated and comment this). Good luck.

Mar 19, 2010 | 1993 Subaru Legacy

1 Answer

Car wont start


If your car is injected it maybe the crankshaft position sensor or the throttle position sensor. Get then tested or replace them.

Jul 04, 2009 | 1995 Subaru Legacy

1 Answer

No Throttle Response - 2006 Hyndai Sonata Diesel Auto


Have dealer check the computer codes - I had same problem and it required that the accelerator module be replaced - this is "drive by wire" system - no direct hookup to the throttle body.

Nov 25, 2008 | 2006 Hyundai Sonata

Not finding what you are looking for?
2006 Subaru Legacy 2.5i Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...