Question about 2002 Lexus RX 300

Open Question

2004 gs 300 lexus p0037 code - 2002 Lexus RX 300

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14036 Answers

SOURCE: Replacement brake pads for 06 Lexus GS 300?

go with standard pads.they wear a little faster than ceramics.but they dont wear down brake rotors.ceramics pads are hard and they cause brakes to squeak.also your car is under warranty with lexus dealership.i would use what they said. because you have future brake problem. they will void out warranty for not using their brakes.

Posted on May 29, 2009

  • 185 Answers

SOURCE: how to get the vsc off my 2000 gs 300 lexus

there is a switch under the dash to turn the vsc on and off. its on the driver side

Posted on Oct 11, 2009

SOURCE: car will not idle 2002 lexus gs 300

if it drives fine off idle then I would suspect the Idle air control valve.
If its hard to start unless you put your foot slightly on the gas then again I would suspect the IAC

Posted on Dec 09, 2009

chrisp2323
  • 36 Answers

SOURCE: moonroof won't open on 1998 Lexsus GS 300

Sounds like a bad switch.

Posted on Apr 26, 2010

  • 72 Answers

SOURCE: The engine light and VSC

your o2 sensor is bad. vsc will go on for any small DTC displayed on the MIL (cel)

P0037 LEXUS P0037 LEXUS - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 2 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
Possible causes - Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
- Faulty Engine Control Module (ECM) When is the code detected? The P0037 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit P0037 LEXUS Description Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECMcontrols the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

o2_heater_circuit.gif

Posted on Mar 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1996 lexus GS 300 starts but won't idle, changed


check the fuel pump fuse in the fuse box

May 22, 2011 | 1996 Lexus GS 300

2 Answers

The engine light and VSC light are on (Vehicle Singapore 2004 Lexus RX 300. Diagnostics report Error code P0037


your o2 sensor is bad. vsc will go on for any small DTC displayed on the MIL (cel)

P0037 LEXUS P0037 LEXUS - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 2 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
Possible causes - Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
- Faulty Engine Control Module (ECM) When is the code detected? The P0037 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit P0037 LEXUS Description Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECMcontrols the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

o2_heater_circuit.gif

Mar 14, 2011 | 2004 Lexus RX 330

1 Answer

Installed a new battery on 1995 lexus 300 and need code for radio and locks to work


Hi, The easy way to get your codes is write down the vin number and call your local lexus dealer with the vin number and the can give you all your codes for your lexus. thanks if i can help you futher just re post.
Thanks dodge tec

Jan 02, 2011 | 1994 Lexus GS 300

1 Answer

The stereo on my lexus gs 300 1994 is showing sec


you need to find the sec(urity) code for the unit.first owner may have written it down ????

Mar 19, 2010 | 2000 Lexus Gs 300

1 Answer

Car will not idle 2002 lexus gs 300


if it drives fine off idle then I would suspect the Idle air control valve.
If its hard to start unless you put your foot slightly on the gas then again I would suspect the IAC

Dec 09, 2009 | 2002 Lexus Gs 300

1 Answer

I have a 1994 lexus GS 300 and the radio shows sec in the display how do I get this off and input the radio code


you have to enter code #, look in manualy they will give instructions on how to enter code also there is a card with radio code. if card is lost call dealer with cars id # and they may be able to give you the code, good luck.

Oct 17, 2009 | 2000 Lexus Gs 300

1 Answer

How to get the vsc off my 2000 gs 300 lexus . The vsc has come on the car how dose get on there.


there is a switch under the dash to turn the vsc on and off. its on the driver side

Oct 10, 2009 | 2000 Lexus Gs 300

1 Answer

Replacement brake pads for 06 Lexus GS 300?


go with standard pads.they wear a little faster than ceramics.but they dont wear down brake rotors.ceramics pads are hard and they cause brakes to squeak.also your car is under warranty with lexus dealership.i would use what they said. because you have future brake problem. they will void out warranty for not using their brakes.

May 29, 2009 | 2006 Lexus Gs 300

1 Answer

Car misfire


For the 1998 Lexus GS 300 3.0 liter DOHC

Firing Order:
1-5-3-6-2-4

Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Dec 30, 2008 | 1998 Lexus Gs 300

Not finding what you are looking for?
2002 Lexus RX 300 Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...