Question about 2010 Nissan Altima
VSP/Slip light and brake light come on while driving. VSP/Slip light stays on and brake light comes on and off.
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Check your brake fluid level in the engine compartment. Its located on the rear RH side of the engine compartment, its a white/clear resevoir connecting to a large black circular object. If the fluid is low, fill to proper level, also I would recommend having your brake system checked as there may be a leak. If the fluid is fine and at the proper level, you may have a damaged/broken brake fluid level sensor or damaged/broken Emergency brake switch. Hopefully this helps....please rate thanks!!
Posted on Aug 09, 2009
SOURCE: brake and battery lights stay on
when both lights stay on with the car running it usually indicates an alternator that is not charging at an acceptable voltage level. check the battery voltage with the car running, if it is under 13.5V you should replace your alternator.
Posted on Dec 12, 2008
Try this, Since you are applying the hand brake. Manually pull up on the emergency pedal and see if the light goes out. If this does work then you could have one of several problems. but, I am thinking that you might be able to adjust the brake tensioner if this car has one.
Posted on Jul 05, 2009
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
Posted on Jan 09, 2010
Tips for a great answer:
Jan 12, 2016 | 2004 Nissan Altima
Sep 13, 2012 | 2010 Nissan Altima
May 19, 2010 | 2003 Nissan Altima
Aug 09, 2009 | 1997 Nissan.5 Altima
Jul 05, 2009 | 1993 Nissan Altima
Dec 12, 2008 | 1999 Nissan Altima
Aug 08, 2008 | 1995 Nissan Altima
470 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: