Question about 1996 Ford Contour
Repair power seat
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
sounds like a bad fuse, have a look at your manual and see which fuse controls those parts, they are most likely on the same fuse, the fuse box may also say which fuse is for what, If the fuse in the first box doesn't fix it, try a new fuse in the box under the hood, let me know how this goes, you may also have corrosion in a wire but check the fuses first.
Posted on Jul 03, 2008
SOURCE: 1997 Ford CV power seat controls
Remove the door trim and you will have full access to what you need.
To remove the door trim you need to remove all the retaining screws (usually there are two screws one on the rear of the door and one on the bottom of the door).
Next you need to remove the casing that surrounds the inside door handle with a flat head screwdriver, once the casing is removed there are 1 or 2 visible screws that need to be removed as well.
Next pry out the window switch housing and unplug the switch.
Finally pull up and out to dislodge the door.
Posted on Apr 22, 2009
SOURCE: DRIVER SIDE WINDOW OFF TRACK
you must pull door panel off (you can find the tool at any parts deals) then lift the window up with hands only it is hard but can be done get some one to hold the window glass up and check to see if any parts have fall if so put back on or replace. if not missing clean track and crank up to glass and line up. wind up and down to make sure it stay and then re-place door panel. hope this works it did for me on my 95 contour
Posted on Jul 05, 2009
This sounding like an Idler bearing problem, Sounds like the idler bearing that supports your belt is either loose or needs replading. I say this because when you get the RPMs up on the motor the noise should almost disappear?
Posted on Aug 30, 2009
check the fuse on the panel, the fuse panel are located in the driver side right by the panel,and check the wires under the seat.
Posted on Sep 15, 2009
Tips for a great answer:
Jan 30, 2016 | 1999 Ford Contour
Dec 29, 2015 | 2003 Chevrolet Avalanche
Jul 21, 2015 | 1998 Ford Contour
Feb 18, 2015 | 1999 Ford Contour
Jun 27, 2011 | Ford Contour Cars & Trucks
Mar 12, 2011 | 1999 Ford Contour
Oct 07, 2009 | 2000 Ford Contour
Aug 19, 2009 | 1998 Ford Contour
Mar 14, 2009 | 1999 Ford Contour
70 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: